[PATCH v8 1/2] dt-bindings: phy: qcom: Add CSI2 C-PHY/DPHY schema

[Bryan O'Donoghue]

On 04/06/2026 10:20, Vladimir Zapolskiy wrote:
> On 6/4/26 12:06, Bryan O'Donoghue wrote:
>> On 04/06/2026 09:46, Vladimir Zapolskiy wrote:
>>> On 6/4/26 03:30, Bryan O'Donoghue wrote:
>>>> On 04/06/2026 01:07, Vladimir Zapolskiy wrote:
>>>>> On 6/4/26 00:18, Bryan O'Donoghue wrote:
>>>>>> On 03/06/2026 21:51, Vladimir Zapolskiy wrote:
>>>>>>>> Actually, one more thing, Why isn't TITAN TOP GDSC here?>>>> +
>>>>>>> If CSIPHYs are true subdevices under the umbrella CAMSS device and
>>>>>>> well
>>>>>>> described as subnodes, then likely none of power domains are needed
>>>>>>> to be
>>>>>>> repeatedly described in the children device nodes, since this
>>>>>>> information
>>>>>>> can be obtained from the parent device by the driver.
>>>>>>>
>>>>>>> Technically 'power-domains' property can be safely removed, I 
>>>>>>> believe.
>>>>>>
>>>>>> The policy is to describe the power-domain dependency fully since DT
>>>>>> describes hardware not software architecture.
>>>>>
>>>>> It brings no contardiction to the statement I've given above, the 
>>>>> needed
>>>>> power domans will be properly described in the parent device, and 
>>>>> there
>>>>> is no
>>>>> sense to repeat the properties it again and again in every child
>>>>> subdevice.
>>>>>
>>>>>> Also for a very practical reason a sub-devices can probe/run
>>>>>> asynchronously of the parent device being active so in fact we do 
>>>>>> need
>>>>>> to describe the PDs fully.
>>>>>
>>>>> In opposite to the above this one is precisely a software centric
>>>>> argument,
>>>>> which should be excluded from the consideration, as well it's not a 
>>>>> big
>>>>> deal to make a proper async initialization, removing excessive dt
>>>>> properties
>>>>> is worth it.
>>>>>
>>>>
>>>> Right look forget about that.
>>>>
>>>> - DT requires you to describe your hardware. You're not entitled to 
>>>> have
>>>>      some other device vote for a clock or a PD you rely on.
>>>>
>>>
>>> Above are two uncorrelated between each other sentences.
>>>
>>> A device ("consumer") can ask another device ("provider") to behave in
>>> one or another way, this is the only possible and thus natually selected
>>> system design, and nothing behind it was asked. There is no 
>>> justification
>>> for the proposed flood of multiply repeated data, it's avoidable.
>>
>> CAMSS or rather the components of CAMSS modelled in the current node,
>> is/are not the provider of the GDSCs or the power-domains, it/they are
>> consumers themselves from CAMCC.
> 
> Well, this is the argument about software, and software can be changed.
> 
>> The producer/consumer model is CAMCC to components within the Camera
>> block. Some components depend on say MXA, MXC, some do not. Nothing in
>> CAMSS itself is a power-domain provider.
>>>>      That's exactly the type of downstream short cut we are trying 
>>>> to zap.
>>>>
>>>> - In our case we also need to vote on PDs individually when the PHY
>>>>      is active.
>>>>
>>>> In extremis say we are only running the TPG then we have no reason to
>>>> vote for CSIPHY specific rails or operating points in the parent 
>>>> device.
>>>
>>> So, TPG shall communicate with CAMSS, there is no CSIPHY in the 
>>> equation.
>>
>> Right but it would be inappropriate to enable all of the PDs for all of
>> the components in the CAMSS block when we can do so more granularly.
> 
> Whenever it is actually necessary, it should be possible to split PDs into
> generic/parent and subdevice specific groups, it's a part of software
> implementation. In some cases there might be no need to define any child
> side PDs, likely CSIPHY falls into this category.


Completely not a discussion about software. DT needs to represent 
hardware. Its a different mindset.

I don't think we are going to resolve this debating the same thing again.

My position is the CSIPHY should list the set of power-domain 
dependencies it has. The PDs don't come from any other thing in the 
CAMSS block so the producer/consumer model is CSIPHY to CAMCC and CSIPHY 
to RPMPD respectively.

I'll just ask @Rob, @Krzysztof or @Conor to offer up their opinion as DT 
maintainers and work from there.

---
bod