[PATCH v13 1/2] dt-bindings: phy: qcom: Add CSI2 C-PHY/DPHY schema

[Bryan O'Donoghue]

On 21/07/2026 10:56, Vladimir Zapolskiy wrote:
> On 7/21/26 12:39, Bryan O'Donoghue wrote:
>> On 21/07/2026 09:17, Vladimir Zapolskiy wrote:
>>>> +  "#phy-cells":
>>>> +    const: 1
>>>> +    description:
>>>> +      The single cell specifies the PHY operating mode.
>>> This has been reported before, #phy-cells shall be 0, the operation
>>> mode is selected by bus-type of endpoints as it is described in
>>> video-interfaces.yaml
>>>
>>> Two competing values are redundant and it opens a door to a wrong
>>> hardware description, the technical discussion has not been started yet.
>> So as I said before, I'm following Rob Herring's input on this and
>> Krzysztof has given RB for this binding. At this stage, I don't see
>> scope to change it.
>>
>> Adding endpoints was already a compromise to address your feedback,
>> which I hoped would bring you on board with the design.
> That's my comment dated March 27, 2026, and it says moving phy type
> from phy cell to the endpoint property excludes the need to set any
> phy cells:
> 
> https://lore.kernel.org/linux-arm-msm/e37ce438-12c7-462d- 
> b2bc-1351be62b806 at linaro.org/
> 
> The technical comment is left unresponded so far since then.
> 
> Since there is no expected phy cells to get on consumer's side, and
> since there is another link between CSIPHY and CSID described in
> video-interfaces.yaml, any kind of dependency of this IP on phy can
> be just removed, which serves the purpose of hardware description
> simplification.

Rob's v1 feedback was consumer-decides-mode via the cell; Krzysztof has
R-b'd the binding with cells=1.

I'm happy to lock down this binding as-is on that basis.

Are you arguing about phy-cells or are you actually arguing the entire
instantiation of Qualcomm MIPI CSI2 as a standalone generic driver in 
drivers/phy ? Its not the same debate at all.

As the CAMSS maintainer, I'm fully against adding more inline monolithic 
CSIPHY init sequences. That could be represented as a separate 
linux-media driver but, then that implies that _all_ upstream CSIPHY 
drivers in drivers/phy are wrong, and I just don't accept that.

The bindings have DT maintainer RB, and the driver has Qcom engineer 
tested-by, review-by.

Vinod, Kishon - Again, I'd request this merges as-is.

---
bod