[PATCH v13 1/2] dt-bindings: phy: qcom: Add CSI2 C-PHY/DPHY schema

[Bryan O'Donoghue]

On 21/07/2026 09:17, Vladimir Zapolskiy wrote:
>> +  "#phy-cells":
>> +    const: 1
>> +    description:
>> +      The single cell specifies the PHY operating mode.
> This has been reported before, #phy-cells shall be 0, the operation
> mode is selected by bus-type of endpoints as it is described in
> video-interfaces.yaml
> 
> Two competing values are redundant and it opens a door to a wrong
> hardware description, the technical discussion has not been started yet.

So as I said before, I'm following Rob Herring's input on this and 
Krzysztof has given RB for this binding. At this stage, I don't see 
scope to change it.

Adding endpoints was already a compromise to address your feedback, 
which I hoped would bring you on board with the design.

There are several SoC bindings as well as new CPHY features which are 
gated on these changes.

Vinod, Kishon I'd request to merge the changes as-is.

---
bod