[PATCH v3 8/9] arm64: dts: st: Add USB nodes on stm32mp231

[Marek Vasut]

On 8/24/26 3:18 PM, Fabrice Gasnier wrote:

[...]

>>   		syscfg: syscon at 44230000 {
>> -			compatible = "st,stm32mp23-syscfg", "syscon";
>> +			compatible = "st,stm32mp23-syscfg", "syscon", "simple-mfd";
>>   			reg = <0x44230000 0x10000>;
>>   			#clock-cells = <0>;
>> +			#address-cells = <1>;
>> +			#size-cells = <1>;
>> +
>> +			usb2_phy1: phy at 2400 {
>> +				compatible = "st,stm32mp25-usb2phy1";
>> +				reg = <0x2400 0x24>;
> 
> Hello Marek,

Hello Fabrice,

> The size 0x24, covers the PHY control, trimming and vbus control logic
> for PHY1 (USBH). So this allows to later extend the driver for that, right ?

Correct.

>> +				#phy-cells = <0>;
>> +				#clock-cells = <1>;
>> +				clocks = <&rcc CK_KER_USB2PHY1>;
>> +				resets = <&rcc USB2PHY1_R>;
>> +				status = "disabled";
>> +			};
>> +
>> +			usb2_phy2: phy at 2800 {
>> +				compatible = "st,stm32mp25-usb2phy2";
>> +				reg = <0x2800 0xc>;
> 
> Then here, I guess the size should cover also trimming regs ? e.g. 0x10 ?
> 				reg = <0x2800 0x10>;
Uh, yes, fixed in V4, thanks !