[PATCH v2 11/14] arm64: dts: qcom: ipq5018: Add Super-Speed UNIPHY to USB node

[Sergey Shtylyov]

On 8/12/26 12:34 PM, George Moussalem via B4 Relay wrote:

> From: George Moussalem <george.moussalem at outlook.com>
> 
> Add the USB3 UNIPHY node to the USB controller node.

   The same comment here...

> In addition, switch to the pipe clock supplied by the USB3 UNIPHY
> instead of the UTMI clock.
> 
> Signed-off-by: George Moussalem <george.moussalem at outlook.com>
> ---
>  arch/arm64/boot/dts/qcom/ipq5018.dtsi | 6 ++----
>  1 file changed, 2 insertions(+), 4 deletions(-)
> 
> diff --git a/arch/arm64/boot/dts/qcom/ipq5018.dtsi b/arch/arm64/boot/dts/qcom/ipq5018.dtsi
> index c98889a7c26c..01b8181ffa40 100644
> --- a/arch/arm64/boot/dts/qcom/ipq5018.dtsi
> +++ b/arch/arm64/boot/dts/qcom/ipq5018.dtsi
> @@ -631,10 +631,8 @@ usb: usb at 8a00000 {
>  
>  			resets = <&gcc GCC_USB0_BCR>;
>  
> -			phys = <&usbphy0>;
> -			phy-names = "usb2-phy";
> -
> -			qcom,select-utmi-as-pipe-clk;
> +			phys = <&usbphy0>, <&usbphy1>;
> +			phy-names = "usb2-phy", "usb3-phy";
>  
>  			tx-fifo-resize;
>  			snps,is-utmi-l1-suspend;
> 

MBR, Sergey