[PATCH 10/10] ARM: dts: qcom: apq8074-dragonboard: enable the HSIC host

[Dmitry Baryshkov]

The dragonboard carries an SMSC USB4604 HSIC hub, but with the HSIC
controller undescribed the whole HSIC-attached part of the board is
dead.

Enable the HSIC controller. The USB4604 hub isn't controllable through
the I2C because of the board design issues, so reference it as a simple
USB device, describing the reset line.

Assisted-by: Claude:claude-fable-5
Signed-off-by: Dmitry Baryshkov <dmitry.baryshkov at oss.qualcomm.com>
---
 .../arm/boot/dts/qcom/qcom-apq8074-dragonboard.dts | 27 ++++++++++++++++++++++
 1 file changed, 27 insertions(+)

diff --git a/arch/arm/boot/dts/qcom/qcom-apq8074-dragonboard.dts b/arch/arm/boot/dts/qcom/qcom-apq8074-dragonboard.dts
index 083fd8fa0aea..02183b37ddbe 100644
--- a/arch/arm/boot/dts/qcom/qcom-apq8074-dragonboard.dts
+++ b/arch/arm/boot/dts/qcom/qcom-apq8074-dragonboard.dts
@@ -158,6 +158,14 @@ &mdss {
 };
 
 &pm8941_gpios {
+	hsic_hub_rst_default: hsic-hub-rst-state {
+		pins = "gpio8";
+		function = "normal";
+		drive-push-pull;
+		qcom,drive-strength = <PMIC_GPIO_STRENGTH_MED>;
+		power-source = <PM8941_GPIO_VPH>;
+	};
+
 	msm_keys_default: pm8941-gpio-keys-state {
 		pins = "gpio5", "gpio23";
 		function = "normal";
@@ -487,6 +495,25 @@ &usb_hs2_phy {
 	qcom,init-seq = /bits/ 8 <0x1 0x63>;
 };
 
+&usb_hsic {
+	pinctrl-0 = <&hsic_hub_rst_default>;
+	pinctrl-names = "default";
+
+	status = "okay";
+
+	#address-cells = <1>;
+	#size-cells = <0>;
+
+	/* SMSC USB4604 hub, standalone mode (SMBus config not usable) */
+	hub at 1 {
+		compatible = "usb424,4604";
+		reg = <1>;
+		clocks = <&rpmcc RPM_SMD_CXO_D1>;
+		reset-gpios = <&pm8941_gpios 8 GPIO_ACTIVE_LOW>;
+		vdd-supply = <&pm8941_s3>;
+	};
+};
+
 &usb3 {
 	dr_mode = "host";
 

-- 
2.47.3