[PATCH 0/2] phy: ti: ti-pipe3: allow configuring ACSPCIe TX/RX mode

[David Oberhollenzer]

This patch set adds a device tree setting to the PIPE3 PHY for
the reference clock selection of the ACSPCIe clock buffer stage.

The clock buffer can operate in either RX mode (clock pins are input,
recover the clock from the bus) or in TX mode (generate the reference
clock for the bus).

This was tested on a board using a phyCORE-AM57x SoM.

David Oberhollenzer (2):
  phy: ti: ti-pipe3: allow configuring ACSPCIe TX/RX mode
  dt-bindings: phy: ti,phy-usb3: document aspcie reference clock setting

 .../devicetree/bindings/phy/ti,phy-usb3.yaml  |  9 +++++++
 drivers/phy/ti/phy-ti-pipe3.c                 | 27 +++++++++++++++++++
 2 files changed, 36 insertions(+)

-- 
2.55.0