[PATCH v4 3/5] phy: qcom: edp: Add SC7280/SC8180X swing/pre-emphasis tables

[Konrad Dybcio]

On 4/23/26 11:32 AM, Konrad Dybcio wrote:
> On 4/23/26 5:28 AM, Yongxing Mou wrote:
>>
>>
>> On 4/22/2026 6:42 PM, Konrad Dybcio wrote:
>>> On 4/22/26 8:01 AM, Yongxing Mou wrote:
>>>> SC7280 and SC8180X previously shared the same cfg because they did not use
>>>> swing/pre-emphasis tables. Add the corresponding tables for these
>>>> platforms. Since they have different PHY sub-versions, their eDP/DP mode
>>>> tables also differ, so move SC8180X to its own cfg instead of reusing the
>>>> SC7280 one.
>>>>
>>>> Signed-off-by: Yongxing Mou <yongxing.mou at oss.qualcomm.com>
>>>> ---
>>>
>>>
>>>
>>>> +static const struct qcom_edp_swing_pre_emph_cfg edp_phy_swing_pre_emph_cfg_v2 = {
>>>> +    .swing_hbr_rbr = &edp_swing_hbr_rbr,
>>>
>>> For eDP / low-Vdiff:
>>>
>>> I believe the RBR swing settings for 8180 should
>>> instead be:
>>>
>>> 0x07 0x0f 0x17 0x1f (matches)
>> Emm i see from ipcat eDP Low vdiff(Lower HBR)  swing settings is
>> 0x07 0x0f 0x16 0x1f
> 
> Yes, you're right, I made a typo
> 
> [...]
> 
>>> .pre_emphasis_hbr3_hbr2 OK
>>> .pre_emphasis_hbr_rbr same as above
>>>
>> Thanks for point this, so pre_emphasis_hbr_rbr same with pre_emphasis_hbr3_hbr2?  I also don't get it's RBR or HBR3 from phy HPG. But now i think only eDP will be used in upstreamed poipu boards. i check the dts and not find any poipu boards will use DP mode(or mini DP)..
> 
> Yeah let's not worry about it today..

About mini-dp specifically that is

Konrad