[PATCH v4 0/5] phy: qcom: edp: Add DP/eDP switch for phys

[Yongxing Mou]

Currently the PHY selects the DP/eDP configuration tables in a fixed way,
choosing the table when enable. This driver has known issues:
1. The selected table does not match the actual platform mode.
2. It cannot support both modes at the same time.

As discussed here[1], this series:
1. Cleans up duplicated and incorrect tables based on the HPG.
2. Fixes the LDO programming error in eDP mode.
3. Adds DP/eDP mode switching support.

Note: x1e80100/sa8775p/sc7280/SC8280XP have been tested, while
glymur/sc8180x have not been tested.

[1] https://lore.kernel.org/all/20260119-klm_dpphy-v2-1-52252190940b@oss.qualcomm.com/

Signed-off-by: Yongxing Mou <yongxing.mou at oss.qualcomm.com>
---
Changes in v4:
- Splite changes.[Dmitry]
- Add sc8180x tables in a single chagne.[Dmitry][Konrad]
- Link to v3: https://lore.kernel.org/r/20260302-edp_phy-v3-0-ca8888d793b0@oss.qualcomm.com

Changes in v3:
- Rebase to next-20260224.[Dmitry]
- Only enable TX1 LDO when lane counts > 2.[Konrad]
- Link to v2: https://lore.kernel.org/all/20260213-edp_phy-v2-0-43c40976435e@oss.qualcomm.com/

Changes in v2:
- Combine the third patch with the first one.[Dmitry]
- Fix code formatting issues.[Konrad][Dmitry]
- Update the commit message description.[Dmitry][Konrad]
- Fix kodiak swing/pre_emp table values.[Konrad]

---
Yongxing Mou (5):
      phy: qcom: edp: Unify generic DP/eDP swing and pre-emphasis tables
      phy: qcom: edp: Add eDP/DP mode switch support
      phy: qcom: edp: Add SC7280/SC8180X swing/pre-emphasis tables
      phy: qcom: edp: Fix AUX_CFG8 programming for DP mode
      phy: qcom: edp: Add PHY-specific LDO config for eDP low vdiff

 drivers/phy/qualcomm/phy-qcom-edp.c | 221 ++++++++++++++++++++++++++++--------
 1 file changed, 173 insertions(+), 48 deletions(-)
---
base-commit: bee6ea30c48788e18348309f891ed8afbf7702ac
change-id: 20260205-edp_phy-1eca3ed074c0

Best regards,
-- 
Yongxing Mou <yongxing.mou at oss.qualcomm.com>