[PATCH v6 12/14] phy: qcom: qmp-usbc: Add QCS615 USB/DP PHY config and DP mode support

[Xiangxu Yin]

On 9/26/2025 5:57 AM, Dmitry Baryshkov wrote:
> On Thu, Sep 25, 2025 at 03:04:58PM +0800, Xiangxu Yin wrote:
>> Add QCS615-specific configuration for USB/DP PHY, including DP init
>> routines, voltage swing tables, and platform data. Add compatible
>> "qcs615-qmp-usb3-dp-phy".
>>
>> Note: SW_PORTSELECT handling for orientation flip is not implemented
>> due to QCS615 fixed-orientation design and non-standard lane mapping.
>>
>> Signed-off-by: Xiangxu Yin <xiangxu.yin at oss.qualcomm.com>
>> ---
>>  drivers/phy/qualcomm/phy-qcom-qmp-usbc.c | 407 +++++++++++++++++++++++++++++++
>>  1 file changed, 407 insertions(+)
>> +
>> +static const struct qmp_phy_init_tbl qmp_v2_dp_serdes_tbl_rbr[] = {
>> +	QMP_PHY_INIT_CFG(QSERDES_COM_HSCLK_SEL, 0x2c),
>> +	QMP_PHY_INIT_CFG(QSERDES_COM_DEC_START_MODE0, 0x69),
>> +	QMP_PHY_INIT_CFG(QSERDES_COM_DIV_FRAC_START1_MODE0, 0x00),
>> +	QMP_PHY_INIT_CFG(QSERDES_COM_DIV_FRAC_START2_MODE0, 0x80),
>> +	QMP_PHY_INIT_CFG(QSERDES_COM_DIV_FRAC_START3_MODE0, 0x07),
>> +	QMP_PHY_INIT_CFG(QSERDES_COM_LOCK_CMP1_MODE0, 0xbf),
>> +	QMP_PHY_INIT_CFG(QSERDES_COM_LOCK_CMP2_MODE0, 0x21),
>> +	QMP_PHY_INIT_CFG(QSERDES_COM_LOCK_CMP3_MODE0, 0x00),
>> +	QMP_PHY_INIT_CFG(QSERDES_V2_TX_LANE_MODE_1, 0xc6),
> Hmm, I just noticed. This register belongs to a _different_ space. As
> such you can't have it in the COM table.


Thanks for pointing this out. It likely worked before because the default
value (0xc6) was sufficient during validation.

I'll move this configuration into configure_dp_tx() and set it based on
link_rate.


>> +};
>> +