[PATCH v3 07/10] phy: qualcomm: qmp-combo: Update QMP PHY with Glymur settings

[Konrad Dybcio]

On 9/25/25 4:28 AM, Wesley Cheng wrote:
> For SuperSpeed USB to work properly, there is a set of HW settings that
> need to be programmed into the USB blocks within the QMP PHY.  Ensure that
> these settings follow the latest settings mentioned in the HW programming
> guide.  The QMP USB PHY on Glymur is a USB43 based PHY that will have some
> new ways to define certain registers, such as the replacement of TXA/RXA
> and TXB/RXB register sets.  This was replaced with the LALB register set.

[...]

> +	/* override hardware control for reset of qmp phy */
> +	if (pcs_aon && cfg->regs[QPHY_AON_TOGGLE_ENABLE])
> +		qphy_clrbits(pcs_aon, cfg->regs[QPHY_AON_TOGGLE_ENABLE], 0x1);

Clearing this field is going to prevent the PHY from ever going offline

The HPG says this should only be necessary for keeping the phy active
during MX retention (and the listed usecases are USB4 wakeup clock
generation via a respective _USB4 register and/or USB3 autonomous mode
operation), both of which are currently unsupported.

Are you sure it's necessary / desired?

Konrad