[PATCH v2 3/4] arm64: dts: qcom: Add PCIe 3 support for HAMOA-IOT-SOM platform

[Ziyue Zhang]

This update enables PCIe3 support by adding necessary sideband signals
(PERST#, WAKE#, CLKREQ#) and required regulators to the PCIe3 controller
and PHY device tree nodes.

These changes ensure correct link initialization and power sequencing for
devices connected via PCIe3.

Signed-off-by: Ziyue Zhang <ziyue.zhang at oss.qualcomm.com>
---
 arch/arm64/boot/dts/qcom/hamoa-iot-som.dtsi | 39 +++++++++++++++++++++
 1 file changed, 39 insertions(+)

diff --git a/arch/arm64/boot/dts/qcom/hamoa-iot-som.dtsi b/arch/arm64/boot/dts/qcom/hamoa-iot-som.dtsi
index 8ea5d0cebe6e..14033d030425 100644
--- a/arch/arm64/boot/dts/qcom/hamoa-iot-som.dtsi
+++ b/arch/arm64/boot/dts/qcom/hamoa-iot-som.dtsi
@@ -390,6 +390,22 @@ &gpu_zap_shader {
 	firmware-name = "qcom/x1e80100/gen70500_zap.mbn";
 };
 
+&pcie3 {
+	pinctrl-names = "default";
+	pinctrl-0 = <&pcie3_default>;
+	perst-gpios = <&tlmm 143 GPIO_ACTIVE_LOW>;
+	wake-gpios = <&tlmm 145 GPIO_ACTIVE_LOW>;
+
+	status = "okay";
+};
+
+&pcie3_phy {
+	vdda-phy-supply = <&vreg_l3c_0p8>;
+	vdda-pll-supply = <&vreg_l3e_1p2>;
+
+	status = "okay";
+};
+
 &pcie4 {
 	perst-gpios = <&tlmm 146 GPIO_ACTIVE_LOW>;
 	wake-gpios = <&tlmm 148 GPIO_ACTIVE_LOW>;
@@ -471,6 +487,29 @@ &tlmm {
 	gpio-reserved-ranges = <34 2>, /* TPM LP & INT */
 			       <44 4>; /* SPI (TPM) */
 
+	pcie3_default: pcie3-default-state {
+		clkreq-n-pins {
+			pins = "gpio144";
+			function = "pcie3_clk";
+			drive-strength = <2>;
+			bias-pull-up;
+		};
+
+		perst-n-pins {
+			pins = "gpio143";
+			function = "gpio";
+			drive-strength = <2>;
+			bias-pull-down;
+		};
+
+		wake-n-pins {
+			pins = "gpio145";
+			function = "gpio";
+			drive-strength = <2>;
+			bias-pull-up;
+		};
+	};
+
 	pcie4_default: pcie4-default-state {
 		clkreq-n-pins {
 			pins = "gpio147";
-- 
2.34.1