[PATCH v7 4/7] reset: rzg2l-usbphy-ctrl: Add support for USB PWRRDY

[Claudiu Beznea]

Hi, Philipp,

On 10/8/25 15:16, Claudiu Beznea wrote:
> Hi, Philipp,
> 
> On 10/8/25 13:23, Philipp Zabel wrote:
>> Hi Claudiu,
>>
>> On Mi, 2025-10-08 at 12:29 +0300, Claudiu Beznea wrote:
>>> Hi, Philipp,
>>>
>>> On 10/8/25 11:34, Philipp Zabel wrote:
>>>> Hi Claudiu,
>>>>
>>>> On Do, 2025-09-25 at 13:02 +0300, Claudiu wrote:
>>>>> From: Claudiu Beznea <claudiu.beznea.uj at bp.renesas.com>
>>>>>
>>>>> On the Renesas RZ/G3S SoC, the USB PHY block has an input signal called
>>>>> PWRRDY. This signal is managed by the system controller and must be
>>>>> de-asserted after powering on the area where USB PHY resides and asserted
>>>>> before powering it off.
>>>>>
>>>>> On power-on the USB PWRRDY signal need to be de-asserted before enabling
>>>>> clock and switching the module to normal state (through MSTOP support). The
>>>>> power-on configuration sequence
>>>> The wording makes me wonder, have you considered implementing this as a
>>>> power sequencing driver?
>>> No, haven't tried as power sequencing. At the moment this was started I
>>> think the power sequencing support wasn't merged.
>>>
>>> The approaches considered were:
>>> a/ power domain
>> Letting a power domain control a corresponding power ready signal would
>> have been my first instinct as well.
>>
>>> b/ regulator
>>> c/ as a reference counted bit done through regmap read/writes APIs
>>>
>>> a and b failed as a result of discussions in the previous posted versions.
>> Could you point me to the discussion related to a?
> It's this one
> https://lore.kernel.org/all/
> CAPDyKFrS4Dhd7DZa2zz=oPro1TiTJFix0awzzzp8Qatm-8Z2Ug at mail.gmail.com/
> 
> 
>> I see v2 and v3 tried to control the bit from the PHY drivers, and in
>> v4 we were are already back to the reset driver.
> v2 passed the system controller (SYSC) phandle to the USB PHYs only (though
> renesas,sysc-signals DT property) where the PWRRDY bit was set. The PWRRDY
> bit was referenced counted in the SYSC driver though regmap APIs.
> 
> v3 used the approach from v2 but passed the renesas,sysc-signals to all the
> USB related drivers.
> 
> Then, in v4, the PWRRDY refcounting was dropped and passed
> renesas,sysc-signals only to the USB PHY CTRL DT node in the idea that this
> is the node that will always be probed first as all the other USB blocks
> need it and request resets from it.
> 
> v5 and v6 kept the approach from v4 and only addressed misc comments or
> things that I noticed.

Could you please let me know if you are OK with the approach proposed in
v7, so that I can start preparing a new version addressing your comments?

Thank you,
Claudiu