[PATCH] phy: ti: gmii-sel: Add a sanity check on the phy_id

[Neil Armstrong]

On 10/17/25 18:04, Dan Carpenter wrote:
> The "phy_id" comes from the device tree so it's going to be correct.
> But static checkers sometimes complain when we have an upper bounds
> check with no lower bounds check.  Also it's a bit unusual that the
> lowest valid number is 1 instead of 0 so adding a check could
> potentially help someone.
> 
> Signed-off-by: Dan Carpenter <dan.carpenter at linaro.org>
> ---
>   drivers/phy/ti/phy-gmii-sel.c | 2 +-
>   1 file changed, 1 insertion(+), 1 deletion(-)
> 
> diff --git a/drivers/phy/ti/phy-gmii-sel.c b/drivers/phy/ti/phy-gmii-sel.c
> index 50adabb867cb..6cfe2538d15b 100644
> --- a/drivers/phy/ti/phy-gmii-sel.c
> +++ b/drivers/phy/ti/phy-gmii-sel.c
> @@ -341,7 +341,7 @@ static struct phy *phy_gmii_sel_of_xlate(struct device *dev,
>   	if (priv->soc_data->features & BIT(PHY_GMII_SEL_RMII_IO_CLK_EN) &&
>   	    args->args_count < 2)
>   		return ERR_PTR(-EINVAL);
> -	if (phy_id > priv->num_ports)
> +	if (phy_id < 1 || phy_id > priv->num_ports)
>   		return ERR_PTR(-EINVAL);
>   	if (phy_id != priv->if_phys[phy_id - 1].id)
>   		return ERR_PTR(-EINVAL);

Reviewed-by: Neil Armstrong <neil.armstrong at linaro.org>