[PATCH v3 0/6] arm64: qcom: allow up to 4 lanes for the Type-C DisplayPort Altmode

[Dmitry Baryshkov]

On Wed, May 28, 2025 at 12:24:02AM +0200, Konrad Dybcio wrote:
> On 5/27/25 11:10 PM, Dmitry Baryshkov wrote:
> > On Tue, May 27, 2025 at 10:40:02PM +0200, Konrad Dybcio wrote:
> >> Register a typec mux in order to change the PHY mode on the Type-C
> >> mux events depending on the mode and the svid when in Altmode setup.
> >>
> >> The DisplayPort phy should be left enabled if is still powered on
> >> by the DRM DisplayPort controller, so bail out until the DisplayPort
> >> PHY is not powered off.
> > 
> > This series doesn't seem to solve the USB side of a problem. When the
> > PHY is being switch to the 4-lane mode, USB controller looses PIPE
> > clock, so it needs to be switched to the USB-2 mode.
> 
> I didn't find issues with that on X13s.. Not sure if it's related, but
> on the SL7, after plugging in a 4ln DP connection, I need to plug in
> the USB thumb drive twice for the first time (only in that sequence)

Might be.

> But there's nothing interesting in dmesg and the phy seems to be
> programmed with the same values on both the initial and the subsequent
> working plug-in

Please try using a DP dongle with USB 2 passthrough (there are some).
Or just emulate this by enabling DP PHY / DP chain for plugged in USB3
devices. Would you be able to see the USB device on a bus?

-- 
With best wishes
Dmitry