[PATCH V4 08/11] phy: qcom-qmp-ufs: refactor qmp_ufs_power_off

[Nitin Rawat]

In qmp_ufs_power_off, the PHY is already powered down by asserting
QPHY_PCS_POWER_DOWN_CONTROL. Therefore, additional phy_reset and
stopping SerDes are unnecessary. Also this approach does not
align with the phy HW programming guide.

Thus, refactor qmp_ufs_power_off to remove the phy_reset and stop
SerDes calls to simplify the code and ensure alignment with the PHY
HW programming guide.

Signed-off-by: Nitin Rawat <quic_nitirawa at quicinc.com>
---
 drivers/phy/qualcomm/phy-qcom-qmp-ufs.c | 7 -------
 1 file changed, 7 deletions(-)

diff --git a/drivers/phy/qualcomm/phy-qcom-qmp-ufs.c b/drivers/phy/qualcomm/phy-qcom-qmp-ufs.c
index 2df61ec68dc7..1cbc255c7c74 100644
--- a/drivers/phy/qualcomm/phy-qcom-qmp-ufs.c
+++ b/drivers/phy/qualcomm/phy-qcom-qmp-ufs.c
@@ -1826,13 +1826,6 @@ static int qmp_ufs_power_off(struct phy *phy)
 	struct qmp_ufs *qmp = phy_get_drvdata(phy);
 	const struct qmp_phy_cfg *cfg = qmp->cfg;

-	/* PHY reset */
-	if (!cfg->no_pcs_sw_reset)
-		qphy_setbits(qmp->pcs, cfg->regs[QPHY_SW_RESET], SW_RESET);
-
-	/* stop SerDes */
-	qphy_clrbits(qmp->pcs, cfg->regs[QPHY_START_CTRL], SERDES_START);
-
 	/* Put PHY into POWER DOWN state: active low */
 	qphy_clrbits(qmp->pcs, cfg->regs[QPHY_PCS_POWER_DOWN_CONTROL],
 			SW_PWRDN);
--
2.48.1