[PATCH 2/2] phy: qcom-mipi-csi2: Add a CSI2 MIPI D-PHY driver

[Bryan O'Donoghue]

On 14/07/2025 15:58, Vladimir Zapolskiy wrote:
> 
> This proposed device node scheme does not solve the known and already
> discussed technical issue expectedly, namely there is no given way
> to describe a combo mode hardware configuration, when two independant
> sensors are wired to the same CSIPHY. This is an unsolvable problem
> with this design.

I think that is genuinely something we should handle in camss-csid.c 
maybe with some meta-data inside of the ports/endpoints..

> 
> Sensors are conneced to CSIPHY IP blocks, CSIPHY is connected to CSID.
My understanding of best practice is data-endpoints go into the consumer 
not the PHY.

These are PHYs with their own SoC pins and voltage rails. They should 
look like other PHYs in qcom and across DT, IMO.

---
bod