[PATCH v4 1/2] phy: cadence: cdns-dphy: Fix PLL lock and O_CMN_READY polling
Devarsh Thakkar
devarsht at ti.com
Fri Jul 4 05:59:14 PDT 2025
PLL lockup and O_CMN_READY assertion can only happen after common state
machine gets enabled by programming DPHY_CMN_SSM register, but driver was
polling them before the common state machine was enabled which is
incorrect. This is as per the DPHY initialization sequence as mentioned in
J721E TRM [1] at section "12.7.2.4.1.2.1 Start-up Sequence Timing Diagram".
It shows O_CMN_READY polling at the end after common configuration pin
setup where the common configuration pin setup step enables state machine
as referenced in "Table 12-1533. Common Configuration-Related Setup
mentions state machine"
To fix this :
- Add new function callbacks for polling on PLL lock and O_CMN_READY
assertion.
- As state machine and clocks get enabled in power_on callback only, move
the clock related programming part from configure callback to power_on
callback and poll for the PLL lockup and O_CMN_READY assertion after state
machine gets enabled.
- The configure callback only saves the PLL configuration received from the
client driver which will be applied later on in power_on callback.
- Add checks to ensure configure is called before power_on and state
machine is in disabled state before power_on callback is called.
- Disable state machine in power_off so that client driver can re-configure
the PLL by following up a power_off, configure, power_on sequence.
[1]: https://www.ti.com/lit/zip/spruil1
Cc: stable at vger.kernel.org
Fixes: 7a343c8bf4b5 ("phy: Add Cadence D-PHY support")
Signed-off-by: Devarsh Thakkar <devarsht at ti.com>
---
V4:
- Optimize wait_for_pll_lock, wait_for_cmn_ready calls to oneline
using conditional operator
- Remove superflous init for ret variable in cdns_dphy_configure
- Enable pll and psm ref clocks before configuring PLL
- Update commit message to refer to TRM
- Rebased on top of:
https://lore.kernel.org/all/20250618-cdns-dsi-impro-v4-4-862c841dbe02@ideasonboard.com/
https://lore.kernel.org/all/20250618-cdns-dsi-impro-v4-5-862c841dbe02@ideasonboard.com/
from the series:
https://lore.kernel.org/all/20250618-cdns-dsi-impro-v4-0-862c841dbe02@ideasonboard.com/
V3:
- Move out clock programming logic to power_on as PLL polling and enable
can happen only after SSM enable
- Disable state machine on power off
V2:
- Return error code on polling timeout
- Moved out calibration logic to separate patch
drivers/phy/cadence/cdns-dphy.c | 124 +++++++++++++++++++++++---------
1 file changed, 92 insertions(+), 32 deletions(-)
diff --git a/drivers/phy/cadence/cdns-dphy.c b/drivers/phy/cadence/cdns-dphy.c
index 33a42e72362e..da8de0a9d086 100644
--- a/drivers/phy/cadence/cdns-dphy.c
+++ b/drivers/phy/cadence/cdns-dphy.c
@@ -92,6 +92,8 @@ struct cdns_dphy_ops {
void (*set_pll_cfg)(struct cdns_dphy *dphy,
const struct cdns_dphy_cfg *cfg);
unsigned long (*get_wakeup_time_ns)(struct cdns_dphy *dphy);
+ int (*wait_for_pll_lock)(struct cdns_dphy *dphy);
+ int (*wait_for_cmn_ready)(struct cdns_dphy *dphy);
};
struct cdns_dphy {
@@ -101,6 +103,8 @@ struct cdns_dphy {
struct clk *pll_ref_clk;
const struct cdns_dphy_ops *ops;
struct phy *phy;
+ bool is_configured;
+ bool is_powered;
};
/* Order of bands is important since the index is the band number. */
@@ -186,6 +190,16 @@ static unsigned long cdns_dphy_get_wakeup_time_ns(struct cdns_dphy *dphy)
return dphy->ops->get_wakeup_time_ns(dphy);
}
+static int cdns_dphy_wait_for_pll_lock(struct cdns_dphy *dphy)
+{
+ return dphy->ops->wait_for_pll_lock ? dphy->ops->wait_for_pll_lock(dphy) : 0;
+}
+
+static int cdns_dphy_wait_for_cmn_ready(struct cdns_dphy *dphy)
+{
+ return dphy->ops->wait_for_cmn_ready ? dphy->ops->wait_for_cmn_ready(dphy) : 0;
+}
+
static unsigned long cdns_dphy_ref_get_wakeup_time_ns(struct cdns_dphy *dphy)
{
/* Default wakeup time is 800 ns (in a simulated environment). */
@@ -227,7 +241,6 @@ static unsigned long cdns_dphy_j721e_get_wakeup_time_ns(struct cdns_dphy *dphy)
static void cdns_dphy_j721e_set_pll_cfg(struct cdns_dphy *dphy,
const struct cdns_dphy_cfg *cfg)
{
- u32 status;
/*
* set the PWM and PLL Byteclk divider settings to recommended values
@@ -244,13 +257,6 @@ static void cdns_dphy_j721e_set_pll_cfg(struct cdns_dphy *dphy,
writel(DPHY_TX_J721E_WIZ_LANE_RSTB,
dphy->regs + DPHY_TX_J721E_WIZ_RST_CTRL);
-
- readl_poll_timeout(dphy->regs + DPHY_TX_J721E_WIZ_PLL_CTRL, status,
- (status & DPHY_TX_WIZ_PLL_LOCK), 0, POLL_TIMEOUT_US);
-
- readl_poll_timeout(dphy->regs + DPHY_TX_J721E_WIZ_STATUS, status,
- (status & DPHY_TX_WIZ_O_CMN_READY), 0,
- POLL_TIMEOUT_US);
}
static void cdns_dphy_j721e_set_psm_div(struct cdns_dphy *dphy, u8 div)
@@ -258,6 +264,23 @@ static void cdns_dphy_j721e_set_psm_div(struct cdns_dphy *dphy, u8 div)
writel(div, dphy->regs + DPHY_TX_J721E_WIZ_PSM_FREQ);
}
+static int cdns_dphy_j721e_wait_for_pll_lock(struct cdns_dphy *dphy)
+{
+ u32 status;
+
+ return readl_poll_timeout(dphy->regs + DPHY_TX_J721E_WIZ_PLL_CTRL, status,
+ status & DPHY_TX_WIZ_PLL_LOCK, 0, POLL_TIMEOUT_US);
+}
+
+static int cdns_dphy_j721e_wait_for_cmn_ready(struct cdns_dphy *dphy)
+{
+ u32 status;
+
+ return readl_poll_timeout(dphy->regs + DPHY_TX_J721E_WIZ_STATUS, status,
+ status & DPHY_TX_WIZ_O_CMN_READY, 0,
+ POLL_TIMEOUT_US);
+}
+
/*
* This is the reference implementation of DPHY hooks. Specific integration of
* this IP may have to re-implement some of them depending on how they decided
@@ -273,6 +296,8 @@ static const struct cdns_dphy_ops j721e_dphy_ops = {
.get_wakeup_time_ns = cdns_dphy_j721e_get_wakeup_time_ns,
.set_pll_cfg = cdns_dphy_j721e_set_pll_cfg,
.set_psm_div = cdns_dphy_j721e_set_psm_div,
+ .wait_for_pll_lock = cdns_dphy_j721e_wait_for_pll_lock,
+ .wait_for_cmn_ready = cdns_dphy_j721e_wait_for_cmn_ready,
};
static int cdns_dphy_config_from_opts(struct phy *phy,
@@ -328,21 +353,36 @@ static int cdns_dphy_validate(struct phy *phy, enum phy_mode mode, int submode,
static int cdns_dphy_configure(struct phy *phy, union phy_configure_opts *opts)
{
struct cdns_dphy *dphy = phy_get_drvdata(phy);
- struct cdns_dphy_cfg cfg = { 0 };
- int ret, band_ctrl;
- unsigned int reg;
+ int ret;
- ret = cdns_dphy_config_from_opts(phy, &opts->mipi_dphy, &cfg);
- if (ret)
- return ret;
+ ret = cdns_dphy_config_from_opts(phy, &opts->mipi_dphy, &dphy->cfg);
+ if (!ret)
+ dphy->is_configured = true;
+
+ return ret;
+}
+
+static int cdns_dphy_power_on(struct phy *phy)
+{
+ struct cdns_dphy *dphy = phy_get_drvdata(phy);
+ int ret;
+ u32 reg;
+
+ if (!dphy->is_configured || dphy->is_powered)
+ return -EINVAL;
+
+ clk_prepare_enable(dphy->psm_clk);
+ clk_prepare_enable(dphy->pll_ref_clk);
/*
* Configure the internal PSM clk divider so that the DPHY has a
* 1MHz clk (or something close).
*/
ret = cdns_dphy_setup_psm(dphy);
- if (ret)
- return ret;
+ if (ret) {
+ dev_err(&dphy->phy->dev, "Failed to setup PSM with error %d\n", ret);
+ goto err_power_on;
+ }
/*
* Configure attach clk lanes to data lanes: the DPHY has 2 clk lanes
@@ -357,40 +397,60 @@ static int cdns_dphy_configure(struct phy *phy, union phy_configure_opts *opts)
* Configure the DPHY PLL that will be used to generate the TX byte
* clk.
*/
- cdns_dphy_set_pll_cfg(dphy, &cfg);
+ cdns_dphy_set_pll_cfg(dphy, &dphy->cfg);
- band_ctrl = cdns_dphy_tx_get_band_ctrl(opts->mipi_dphy.hs_clk_rate);
- if (band_ctrl < 0)
- return band_ctrl;
+ ret = cdns_dphy_tx_get_band_ctrl(dphy->cfg.hs_clk_rate);
+ if (ret < 0) {
+ dev_err(&dphy->phy->dev, "Failed to get band control value with error %d\n", ret);
+ goto err_power_on;
+ }
- reg = FIELD_PREP(DPHY_BAND_CFG_LEFT_BAND, band_ctrl) |
- FIELD_PREP(DPHY_BAND_CFG_RIGHT_BAND, band_ctrl);
+ reg = FIELD_PREP(DPHY_BAND_CFG_LEFT_BAND, ret) |
+ FIELD_PREP(DPHY_BAND_CFG_RIGHT_BAND, ret);
writel(reg, dphy->regs + DPHY_BAND_CFG);
- return 0;
-}
-
-static int cdns_dphy_power_on(struct phy *phy)
-{
- struct cdns_dphy *dphy = phy_get_drvdata(phy);
-
- clk_prepare_enable(dphy->psm_clk);
- clk_prepare_enable(dphy->pll_ref_clk);
-
/* Start TX state machine. */
writel(DPHY_CMN_SSM_EN | DPHY_CMN_TX_MODE_EN,
dphy->regs + DPHY_CMN_SSM);
+ ret = cdns_dphy_wait_for_pll_lock(dphy);
+ if (ret) {
+ dev_err(&dphy->phy->dev, "Failed to lock PLL with error %d\n", ret);
+ goto err_power_on;
+ }
+
+ ret = cdns_dphy_wait_for_cmn_ready(dphy);
+ if (ret) {
+ dev_err(&dphy->phy->dev, "O_CMN_READY signal failed to assert with error %d\n",
+ ret);
+ goto err_power_on;
+ }
+
+ dphy->is_powered = true;
+
return 0;
+
+err_power_on:
+ clk_disable_unprepare(dphy->pll_ref_clk);
+ clk_disable_unprepare(dphy->psm_clk);
+
+ return ret;
}
static int cdns_dphy_power_off(struct phy *phy)
{
struct cdns_dphy *dphy = phy_get_drvdata(phy);
+ u32 reg;
clk_disable_unprepare(dphy->pll_ref_clk);
clk_disable_unprepare(dphy->psm_clk);
+ /* Stop TX state machine. */
+ reg = readl(dphy->regs + DPHY_CMN_SSM);
+ writel(reg & ~DPHY_CMN_SSM_EN, dphy->regs + DPHY_CMN_SSM);
+
+ dphy->is_powered = false;
+
return 0;
}
--
2.39.1
More information about the linux-phy
mailing list