[PATCH v2 5/5] phy: renesas: rcar-gen3-usb2: Set timing registers only once

[Lad, Prabhakar]

On Tue, Feb 25, 2025 at 11:02 AM Claudiu <claudiu.beznea at tuxon.dev> wrote:
>
> From: Claudiu Beznea <claudiu.beznea.uj at bp.renesas.com>
>
> phy-rcar-gen3-usb2 driver exports 4 PHYs. The timing registers are common
> to all PHYs. There is no need to set them every time a PHY is initialized.
> Set timing register only when the 1st PHY is initialized.
>
> Fixes: f3b5a8d9b50d ("phy: rcar-gen3-usb2: Add R-Car Gen3 USB2 PHY driver")
> Cc: stable at vger.kernel.org
> Reviewed-by: Yoshihiro Shimoda <yoshihiro.shimoda.uh at renesas.com>
> Tested-by: Yoshihiro Shimoda <yoshihiro.shimoda.uh at renesas.com>
> Signed-off-by: Claudiu Beznea <claudiu.beznea.uj at bp.renesas.com>
> ---
>
> Changes in v2:
> - collected tags
>
>  drivers/phy/renesas/phy-rcar-gen3-usb2.c | 7 +++++--
>  1 file changed, 5 insertions(+), 2 deletions(-)
>
Reviewed-by: Lad Prabhakar <prabhakar.mahadev-lad.rj at bp.renesas.com>

Cheers,
Prabhakar

> diff --git a/drivers/phy/renesas/phy-rcar-gen3-usb2.c b/drivers/phy/renesas/phy-rcar-gen3-usb2.c
> index 21cf14ea3437..a89621d3f94b 100644
> --- a/drivers/phy/renesas/phy-rcar-gen3-usb2.c
> +++ b/drivers/phy/renesas/phy-rcar-gen3-usb2.c
> @@ -467,8 +467,11 @@ static int rcar_gen3_phy_usb2_init(struct phy *p)
>         val = readl(usb2_base + USB2_INT_ENABLE);
>         val |= USB2_INT_ENABLE_UCOM_INTEN | rphy->int_enable_bits;
>         writel(val, usb2_base + USB2_INT_ENABLE);
> -       writel(USB2_SPD_RSM_TIMSET_INIT, usb2_base + USB2_SPD_RSM_TIMSET);
> -       writel(USB2_OC_TIMSET_INIT, usb2_base + USB2_OC_TIMSET);
> +
> +       if (!rcar_gen3_is_any_rphy_initialized(channel)) {
> +               writel(USB2_SPD_RSM_TIMSET_INIT, usb2_base + USB2_SPD_RSM_TIMSET);
> +               writel(USB2_OC_TIMSET_INIT, usb2_base + USB2_OC_TIMSET);
> +       }
>
>         /* Initialize otg part (only if we initialize a PHY with IRQs). */
>         if (rphy->int_enable_bits)
> --
> 2.43.0
>
>