[PATCH V3 0/9] Refactor phy powerup sequence

[Dmitry Baryshkov]

On Thu, Apr 10, 2025 at 02:30:53PM +0530, Nitin Rawat wrote:
> In Current code regulators enable, clks enable, calibrating UFS PHY,
> start_serdes and polling PCS_ready_status are part of phy_power_on.
> 
> UFS PHY registers are retained after power collapse, meaning calibrating
> UFS PHY, start_serdes and polling PCS_ready_status can be done only when
> hba is powered_on, and not needed every time when phy_power_on is called
> during resume. Hence keep the code which enables PHY's regulators & clks
> in phy_power_on and move the rest steps into phy_calibrate function.
> 
> Since phy_power_on is separated out from phy calibrate, make separate calls
> to phy_power_on and phy_calibrate calls from ufs qcom driver.
> 
> Also for better power saving, remove the phy_power_on/off calls from
> resume/suspend path and put them to ufs_qcom_setup_clocks, so that
> PHY's regulators & clks can be turned on/off along with UFS's clocks.

Please add an explicit note that patch1 is a requirement for the rest of
the PHY patches. It might make sense to merge it through the PHY tree
too (or to use an immutable branch).

> 
> This patch series is tested on SM8550 QRD, SM8650 MTP , SM8750 MTP.
> 

-- 
With best wishes
Dmitry