[PATCH V2 1/3] phy: freescale: fsl-samsung-hdmi: Expand Integer divider range

[Adam Ford]

The Integer divder uses values of P,M, and S to determine the PLL
rate.  Currently, the range of M was set based on a series of
table entries where the range was limited.  Since the ref manual
shows it is 8-bit wide, expand the range to be up to 255.

Signed-off-by: Adam Ford <aford173 at gmail.com>
Reviewed-by: Frieder Schrempf <frieder.schrempf at kontron.de>
---
V2:  Fix typo in comment

diff --git a/drivers/phy/freescale/phy-fsl-samsung-hdmi.c b/drivers/phy/freescale/phy-fsl-samsung-hdmi.c
index 2c8038864357..412c03b7dcd6 100644
--- a/drivers/phy/freescale/phy-fsl-samsung-hdmi.c
+++ b/drivers/phy/freescale/phy-fsl-samsung-hdmi.c
@@ -406,16 +406,15 @@ static unsigned long fsl_samsung_hdmi_phy_find_pms(unsigned long fout, u8 *p, u1
 				continue;
 
 			/*
-			 * TODO: Ref Manual doesn't state the range of _m
-			 * so this should be further refined if possible.
-			 * This range was set based on the original values
-			 * in the lookup table
+			 * The Ref manual doesn't explicitly state the range of M,
+			 * but it does show it as an 8-bit value, so reject
+			 * any value above 255.
 			 */
 			tmp = (u64)fout * (_p * _s);
 			do_div(tmp, 24 * MHZ);
-			_m = tmp;
-			if (_m < 0x30 || _m > 0x7b)
+			if (tmp > 255)
 				continue;
+			_m = tmp;
 
 			/*
 			 * Rev 2 of the Ref Manual states the
-- 
2.45.2