[PATCH 1/3] phy: freescale: fsl-samsung-hdmi: Expand Integer divider range

[Frieder Schrempf]

On 20.10.24 6:50 PM, Adam Ford wrote:
> The Integer divder uses values of P,M, and S to determine the PLL
> rate.  Currently, the range of M was set based on a series of
> table entries where the range was limited.  Since the ref manual
> shows it is 8-bit wide, expand the range to be up to 255.
> 
> Signed-off-by: Adam Ford <aford173 at gmail.com>

With the typo below fixed:

Reviewed-by: Frieder Schrempf <frieder.schrempf at kontron.de>

> ---
>  drivers/phy/freescale/phy-fsl-samsung-hdmi.c | 11 +++++------
>  1 file changed, 5 insertions(+), 6 deletions(-)
> 
> diff --git a/drivers/phy/freescale/phy-fsl-samsung-hdmi.c b/drivers/phy/freescale/phy-fsl-samsung-hdmi.c
> index 2c8038864357..3f9578f3f0ac 100644
> --- a/drivers/phy/freescale/phy-fsl-samsung-hdmi.c
> +++ b/drivers/phy/freescale/phy-fsl-samsung-hdmi.c
> @@ -406,16 +406,15 @@ static unsigned long fsl_samsung_hdmi_phy_find_pms(unsigned long fout, u8 *p, u1
>  				continue;
>  
>  			/*
> -			 * TODO: Ref Manual doesn't state the range of _m
> -			 * so this should be further refined if possible.
> -			 * This range was set based on the original values
> -			 * in the lookup table
> +			 * The Ref manual doesn't explicitly state the range of M,
> +			 * bit it does show it as an 8-bit value, so we'll reject

                           ^ but

> +			 * any value above 255.
>  			 */
>  			tmp = (u64)fout * (_p * _s);
>  			do_div(tmp, 24 * MHZ);
> -			_m = tmp;
> -			if (_m < 0x30 || _m > 0x7b)
> +			if (tmp > 255)
>  				continue;
> +			_m = tmp;
>  
>  			/*
>  			 * Rev 2 of the Ref Manual states the