[PATCH] dt-bindings: phy: qcom,sc8280xp-qmp-pcie-phy: Fix X1E80100 resets entries

[Abel Vesa]

On 24-10-21 10:59:54, Johan Hovold wrote:
> On Mon, Oct 21, 2024 at 11:53:31AM +0300, Abel Vesa wrote:
> > On 24-10-21 09:33:20, Johan Hovold wrote:
> > > On Fri, Oct 18, 2024 at 04:37:36PM +0300, Abel Vesa wrote:
> > > > The PCIe 6a PHY on X1E80100 uses both resets in 4-lanes mode as well.
> > > 
> > > Again, this is a bit misleading as PCIe6a is using the
> > > 'qcom,x1e80100-qmp-gen4x4-pcie-phy' compatible in both 4-lane and 2-lane
> > > mode even if the original dtsi got this wrong.
> > 
> > But the lane config within the phy driver differs based on the
> > compatible.
> 
> No, it differs based on the value of the TCSR register.

Yep, realized that now. Thanks for confirming.

> 
> > > PCIe6b will be using 'qcom,x1e80100-qmp-gen4x2-pcie-phy' as that one is
> > > a 2-lane PHY.
> > 
> > Wouldn't the PCIe6a also have to switch to gen4x2 compatible on a board
> > where PCIe6b is used?
> 
> Nope, it stays the same (e.g. as the hardware block is the same).
> 
> > > Perhaps you can rephrase this so that it doesn't sound like you are
> > > using compatibles to configure PCIe6a?
> > 
> > But currently we do configure PCIe6a based on compatibles.
> > 
> > What am I missing ?
> 
> No, as we've discussed in multiple threads already:
> 
> 	https://lore.kernel.org/all/ZwPDxd9JJbgDeJTi@hovoldconsulting.com/	
> 	https://lore.kernel.org/lkml/ZtG2dUVkdwBpBbix@hovoldconsulting.com/
> 
> Johan