[PATCH V2 1/3] phy: freescale: fsl-samsung-hdmi: Expand Integer divider range

[Adam Ford]

On Sat, Oct 26, 2024 at 8:20 AM Adam Ford <aford173 at gmail.com> wrote:
>
> The Integer divder uses values of P,M, and S to determine the PLL
> rate.  Currently, the range of M was set based on a series of
> table entries where the range was limited.  Since the ref manual
> shows it is 8-bit wide, expand the range to be up to 255.
>
> Signed-off-by: Adam Ford <aford173 at gmail.com>
> Reviewed-by: Frieder Schrempf <frieder.schrempf at kontron.de>
> ---
> V2:  Fix typo in comment

Vinod,

Is there any chance this series could also be applied for the next
release?  I don't know what the cutoff deadline is, so if I'm too
late, I apologize.

adam
>
> diff --git a/drivers/phy/freescale/phy-fsl-samsung-hdmi.c b/drivers/phy/freescale/phy-fsl-samsung-hdmi.c
> index 2c8038864357..412c03b7dcd6 100644
> --- a/drivers/phy/freescale/phy-fsl-samsung-hdmi.c
> +++ b/drivers/phy/freescale/phy-fsl-samsung-hdmi.c
> @@ -406,16 +406,15 @@ static unsigned long fsl_samsung_hdmi_phy_find_pms(unsigned long fout, u8 *p, u1
>                                 continue;
>
>                         /*
> -                        * TODO: Ref Manual doesn't state the range of _m
> -                        * so this should be further refined if possible.
> -                        * This range was set based on the original values
> -                        * in the lookup table
> +                        * The Ref manual doesn't explicitly state the range of M,
> +                        * but it does show it as an 8-bit value, so reject
> +                        * any value above 255.
>                          */
>                         tmp = (u64)fout * (_p * _s);
>                         do_div(tmp, 24 * MHZ);
> -                       _m = tmp;
> -                       if (_m < 0x30 || _m > 0x7b)
> +                       if (tmp > 255)
>                                 continue;
> +                       _m = tmp;
>
>                         /*
>                          * Rev 2 of the Ref Manual states the
> --
> 2.45.2
>