[PATCH RFC v3 4/5] phy: hisilicon: hisi-inno-phy: add support for Hi3798MV200 INNO PHY

[Philipp Zabel]

On Di, 2024-02-20 at 05:28 +0800, Yang Xiwen via B4 Relay wrote:
> From: Yang Xiwen <forbidden405 at outlook.com>
> 
> Direct MMIO resgiter access is used by Hi3798MV200. For other models,

              register

> of_iomap() returns 0 due to insufficient length. So they are unaffected.
> 
> Also Hi3798MV200 INNO PHY has an extra reset required to be deasserted,
> switch to reset_control_bulk_() APIs to resolve this.

            reset_control_array_()

apparently.

> Signed-off-by: Yang Xiwen <forbidden405 at outlook.com>
> ---
>  drivers/phy/hisilicon/phy-hisi-inno-usb2.c | 65 ++++++++++++++++++------------
>  1 file changed, 39 insertions(+), 26 deletions(-)
> 
> diff --git a/drivers/phy/hisilicon/phy-hisi-inno-usb2.c b/drivers/phy/hisilicon/phy-hisi-inno-usb2.c
> index b7e740eb4752..5175e5a351ac 100644
> --- a/drivers/phy/hisilicon/phy-hisi-inno-usb2.c
> +++ b/drivers/phy/hisilicon/phy-hisi-inno-usb2.c
> @@ -10,6 +10,7 @@
>  #include <linux/io.h>
>  #include <linux/module.h>
>  #include <linux/of.h>
> +#include <linux/of_address.h>
>  #include <linux/phy/phy.h>
>  #include <linux/platform_device.h>
>  #include <linux/reset.h>
> @@ -43,6 +44,7 @@
>  #define PHY_CLK_ENABLE		BIT(2)
>  
>  struct hisi_inno_phy_port {
> +	void __iomem *base;
>  	struct reset_control *utmi_rst;
>  	struct hisi_inno_phy_priv *priv;
>  };
> @@ -50,7 +52,7 @@ struct hisi_inno_phy_port {
>  struct hisi_inno_phy_priv {
>  	void __iomem *mmio;
>  	struct clk *ref_clk;
> -	struct reset_control *por_rst;
> +	struct reset_control *rsts;
>  	unsigned int type;
>  	struct hisi_inno_phy_port ports[INNO_PHY_PORT_NUM];
>  };
> @@ -62,26 +64,31 @@ static void hisi_inno_phy_write_reg(struct hisi_inno_phy_priv *priv,
>  	u32 val;
>  	u32 value;
>  
> -	if (priv->type == PHY_TYPE_0)
> -		val = (data & PHY_TEST_DATA) |
> -		      ((addr << PHY_TEST_ADDR_OFFSET) & PHY0_TEST_ADDR) |
> -		      ((port << PHY0_TEST_PORT_OFFSET) & PHY0_TEST_PORT) |
> -		      PHY0_TEST_WREN | PHY0_TEST_RST;
> -	else
> -		val = (data & PHY_TEST_DATA) |
> -		      ((addr << PHY_TEST_ADDR_OFFSET) & PHY1_TEST_ADDR) |
> -		      ((port << PHY1_TEST_PORT_OFFSET) & PHY1_TEST_PORT) |
> -		      PHY1_TEST_WREN | PHY1_TEST_RST;
> -	writel(val, reg);
> -
> -	value = val;
> -	if (priv->type == PHY_TYPE_0)
> -		value |= PHY0_TEST_CLK;
> -	else
> -		value |= PHY1_TEST_CLK;
> -	writel(value, reg);
> -
> -	writel(val, reg);
> +	if (priv->ports[port].base)
> +		// stride is 4
> +		writel(data, (u32 *)priv->ports[port].base + addr);
> +	else {
> +		if (priv->type == PHY_TYPE_0)
> +			val = (data & PHY_TEST_DATA) |
> +			      ((addr << PHY_TEST_ADDR_OFFSET) & PHY0_TEST_ADDR) |
> +			      ((port << PHY0_TEST_PORT_OFFSET) & PHY0_TEST_PORT) |
> +			      PHY0_TEST_WREN | PHY0_TEST_RST;
> +		else
> +			val = (data & PHY_TEST_DATA) |
> +			      ((addr << PHY_TEST_ADDR_OFFSET) & PHY1_TEST_ADDR) |
> +			      ((port << PHY1_TEST_PORT_OFFSET) & PHY1_TEST_PORT) |
> +			      PHY1_TEST_WREN | PHY1_TEST_RST;
> +		writel(val, reg);
> +
> +		value = val;
> +		if (priv->type == PHY_TYPE_0)
> +			value |= PHY0_TEST_CLK;
> +		else
> +			value |= PHY1_TEST_CLK;
> +		writel(value, reg);
> +
> +		writel(val, reg);
> +	}
>  }
>  
>  static void hisi_inno_phy_setup(struct hisi_inno_phy_priv *priv)
> @@ -104,7 +111,7 @@ static int hisi_inno_phy_init(struct phy *phy)
>  		return ret;
>  	udelay(REF_CLK_STABLE_TIME);
>  
> -	reset_control_deassert(priv->por_rst);
> +	reset_control_deassert(priv->rsts);
>  	udelay(POR_RST_COMPLETE_TIME);
>  
>  	/* Set up phy registers */
> @@ -122,7 +129,7 @@ static int hisi_inno_phy_exit(struct phy *phy)
>  	struct hisi_inno_phy_priv *priv = port->priv;
>  
>  	reset_control_assert(port->utmi_rst);
> -	reset_control_assert(priv->por_rst);
> +	reset_control_assert(priv->rsts);
>  	clk_disable_unprepare(priv->ref_clk);
>  
>  	return 0;
> @@ -158,15 +165,16 @@ static int hisi_inno_phy_probe(struct platform_device *pdev)
>  	if (IS_ERR(priv->ref_clk))
>  		return PTR_ERR(priv->ref_clk);
>  
> -	priv->por_rst = devm_reset_control_get_exclusive(dev, NULL);
> -	if (IS_ERR(priv->por_rst))
> -		return PTR_ERR(priv->por_rst);
> +	priv->rsts = devm_reset_control_array_get(dev, false, false);

Please use devm_reset_control_array_get_exclusive() instead.


regards
Philipp