[PATCH RFC 0/4] phy: hisi-inno-phy: add support for hi3798mv200-usb2-phy

[Yang Xiwen via B4 Relay]

This should be considered a dirty hack. The proper solution would be
extracting write_reg logic to a separate regmap driver. Leaving only
"write BIT(2) to address 0x6" to the PHY driver.

The initial commit is already doing things wrong. The following patches
adding hi3798mv100 support is also very confusing. The name of the
enumeration "PHY_TYPE_x" is very misleading as if it's the phy which is
different across SoCs. But actually it's the bus (i.e. how to write to a
given address) which is different, not the PHY.

Signed-off-by: Yang Xiwen <forbidden405 at outlook.com>
---
Yang Xiwen (4):
      dt-binding: phy: hisi-inno-usb2: convert to YAML
      phy: hisilicon: enable clocks for every ports
      phy: hisi-inno-usb2: add support for direct MMIO
      dt-binding: phy: hisi-inno-usb2: add compatible of hisilicon,hi3798mv200-usb2-phy

 .../bindings/phy/hisilicon,inno-usb2-phy.yaml      | 125 +++++++++++++++++++++
 .../devicetree/bindings/phy/phy-hisi-inno-usb2.txt |  71 ------------
 drivers/phy/hisilicon/phy-hisi-inno-usb2.c         |  57 ++++++----
 3 files changed, 161 insertions(+), 92 deletions(-)
---
base-commit: 8d3dea210042f54b952b481838c1e7dfc4ec751d
change-id: 20240216-inno-phy-a2d872f6b74b

Best regards,
-- 
Yang Xiwen <forbidden405 at outlook.com>