[PATCH v3 08/18] phy: ti: phy-j721e-wiz: split wiz_clock_init() function

[Siddharth Vadapalli]

On 24/02/16 11:32AM, Vinod Koul wrote:
> On 15-02-24, 17:43, Andy Shevchenko wrote:
> > On Thu, Feb 15, 2024 at 04:17:53PM +0100, Thomas Richard wrote:
> > > The wiz_clock_init() function mixes probe and hardware configuration.
> > > Rename the wiz_clock_init() to wiz_clock_probe() and move the hardware
> > > configuration part in a new function named wiz_clock_init().
> > > 
> > > This hardware configuration sequence must be called during the resume
> > > stage of the driver.
> > 
> > ...
> > 
> > (Side note, as this can be done later)
> > 
> > >  	if (rate >= 100000000)
> > 
> > > +		if (rate >= 100000000)
> > 
> > > +	if (rate >= 100000000)
> > 
> > I would make local definition and use it, we may get the global one as there
> > are users.
> > 
> > #define HZ_PER_GHZ	1000000000UL
> 
> Better to define as:
> #define HZ_PER_GHZ 1 * GIGA

The variable "rate" is being compared against 100 MHz and not 1 GHz.
The driver already has the following macros defined:
#define REF_CLK_19_2MHZ         19200000
#define REF_CLK_25MHZ           25000000
#define REF_CLK_100MHZ          100000000
#define REF_CLK_156_25MHZ       156250000

So would it be acceptable to change it to:
	if (rate >= REF_CLK_100MHZ)
instead?

Regards,
Siddharth.