[PATCH v4 6/7] phy: exynos5-usbdrd: subscribe to orientation notifier if required

[Peter Griffin]

Hi André,

On Sat, 7 Dec 2024 at 21:31, Peter Griffin <peter.griffin at linaro.org> wrote:
>
> Hi André,
>
> Firstly, thanks for all your work getting USB on Pixel 6 / gs101
> working upstream :)
>
> On Fri, 6 Dec 2024 at 16:31, André Draszik <andre.draszik at linaro.org> wrote:
> >
> > gs101's SS phy needs to be configured differently based on the
> > connector orientation, as the SS link can only be established if the
> > mux is configured correctly.
> >
> > The code to handle programming of the mux is in place already, this commit
> > now adds the missing pieces to subscribe to the Type-C orientation
> > switch event.
> >
> > Note that for this all to work we rely on the USB controller
> > re-initialising us. It should invoke our .exit() upon cable unplug, and
> > during cable plug we'll receive the orientation event after which we
> > expect our .init() to be called.
> >
> > Above reinitialisation happens if the DWC3 controller can enter runtime
> > suspend automatically. For the DWC3 driver, this is an opt-in:
> >     echo auto > /sys/devices/.../11110000.usb/power/control
> > Once done, things work as long as the UDC is not bound as otherwise it
> > stays busy because it doesn't cancel / stop outstanding TRBs. For now
> > we have to manually unbind the UDC in that case:
> >      echo "" > sys/kernel/config/usb_gadget/.../UDC
> >
> > Note that if the orientation-switch property is missing from the DT,
> > the code will behave as before this commit (meaning for gs101 it will
> > work in SS mode in one orientation only). Other platforms are not
> > affected either way.
> >
> > Signed-off-by: André Draszik <andre.draszik at linaro.org>
>
> Reviewed-by: Peter Griffin <peter.griffin at linaro.org>
> Tested-by: Peter Griffin <peter.griffin at linaro.org>
>
> Notes on testing:
>
> I tested this series with the corresponding DT using a Pixel 6 device
> with 2 different USB hubs and also plugging directly into my laptop.
> I've tried various combinations of plugging / unplugging from both
> ends of the USB cable and changing cable orientation. With the latest
> series the disconnect/reconnect always seems robustly detected and
> Pixel is enumerated as a USB device by the host, adb connection to the
> phone is possible even with the cable orientation changing between
> disconnect/reconnect.
>
> One thing I did notice during testing is that in one cable orientation
> Pixel is detected as a `SuperSpeed USB device` by the host and in the
> other cable orientation it is detected as a `high-speed USB device`.
> Which suggests there is still a latent bug in the phy
> re-configuration.

You can disregard this last point, I had a typo in my test setup :( I
just confirmed that it is detected as SuperSpeed in both orientations.

Thanks,

Peter