[RFC v3 4/7] phy: qcom: Add QCOM SNPS eUSB2 repeater driver

[Abel Vesa]

On 23-02-03 18:51:13, Dmitry Baryshkov wrote:
> On 02/02/2023 15:38, Abel Vesa wrote:
> > PM8550B contains a eUSB2 repeater used for making the eUSB2 from
> > SM8550 USB 2.0 compliant. This can be modelled SW-wise as a Phy.
> > So add a new phy driver for it.
> > 
> > Signed-off-by: Abel Vesa <abel.vesa at linaro.org>
> > ---
> >   drivers/phy/qualcomm/Kconfig                  |   9 +
> >   drivers/phy/qualcomm/Makefile                 |   1 +
> >   .../phy/qualcomm/phy-qcom-eusb2-repeater.c    | 278 ++++++++++++++++++
> >   3 files changed, 288 insertions(+)
> >   create mode 100644 drivers/phy/qualcomm/phy-qcom-eusb2-repeater.c
> > 

[ ... ]

> > +
> > +static int eusb2_repeater_init(struct phy *phy)
> > +{
> > +	struct eusb2_repeater *rptr = phy_get_drvdata(phy);
> > +	const struct eusb2_repeater_init_tbl *init_tbl = rptr->cfg->init_tbl;
> > +	int num = rptr->cfg->init_tbl_num;
> > +	int ret = 0;
> > +	u32 val;
> > +	int i;
> > +
> > +	ret = regulator_bulk_enable(rptr->cfg->num_vregs, rptr->vregs);
> > +	if (ret)
> > +		return ret;
> > +
> > +	regmap_update_bits(rptr->regmap, rptr->base + EUSB2_EN_CTL1,
> > +				EUSB2_RPTR_EN, EUSB2_RPTR_EN);
> > +
> > +	for (i = 0; i < num; i++)
> > +		regmap_update_bits(rptr->regmap,
> > +					rptr->base + init_tbl[i].offset,
> > +					init_tbl[i].val, init_tbl[i].val);
> 
> I'd move this to a separate function. Then you can use it in the set_mode()
> too.
> 

I don't think this is necessary in set_mode.

> > +
> > +	ret = regmap_read_poll_timeout(rptr->regmap,
> > +					rptr->base + EUSB2_RPTR_STATUS, val,
> > +					val & RPTR_OK, 10, 5);
> > +	if (ret)
> > +		dev_err(rptr->dev, "initialization timed-out\n");
> > +
> > +	return ret;
> > +}
> > +

[ ... ]