[PATCH v2 0/2] phy: qcom: edp: Allow eDP/DP configuring via set_mode op

[Abel Vesa]

On 23-12-22 16:02:56, Konrad Dybcio wrote:
> On 22.12.2023 14:01, Abel Vesa wrote:
> > Until now, all platform that supported both eDP and DP had different
> > compatibles for each mode. Using different compatibles for basically
> > the same IP block but for a different configuration is bad way all
> > around. There is a new compute platform from Qualcomm that supports
> > both eDP and DP with the same PHY. So instead of following the old
> > method, we should allow the mode to be configured via set_mode from
> > the controller driver.
> > 
> > The controller part will follow after we conclude the PHY part first.
> I got a bit lost between all the propositions, how are we going to
> discern the controller modes going forward?

Have a look here:
https://lore.kernel.org/all/CAA8EJpr8rKMBzcm-=HGu7-C5hPkNMrnG1cA78O00UjgJVT7p6Q@mail.gmail.com/

I currently implemented this locally, using the is-edp property.

Whatever property we will end up using for specifying the mode in the
controller mode, the set_mode op is still needed in the phy driver.

> 
> Konrad