[PATCH v2 1/2] dt-bindings: phy: mediatek: tphy: add a property for force-mode switch

Chunfeng Yun chunfeng.yun at mediatek.com
Sun Dec 10 18:56:23 PST 2023


Due to some old SoCs with shared t-phy between usb3 and pcie only support
force-mode switch, and shared and non-shared t-phy may exist at the same
time on a SoC, can't use compatible to distinguish between shared and
non-shared t-phy, add a property to supported it.
Currently, only support switch from default pcie mode to usb3 mode.
But now prefer to use "mediatek,syscon-type" on new SoC as far as possible.

Signed-off-by: Chunfeng Yun <chunfeng.yun at mediatek.com>
---
v2: modify commit message, and property description 
---
 Documentation/devicetree/bindings/phy/mediatek,tphy.yaml | 9 +++++++++
 1 file changed, 9 insertions(+)

diff --git a/Documentation/devicetree/bindings/phy/mediatek,tphy.yaml b/Documentation/devicetree/bindings/phy/mediatek,tphy.yaml
index 2bb91542e984..acba0720125d 100644
--- a/Documentation/devicetree/bindings/phy/mediatek,tphy.yaml
+++ b/Documentation/devicetree/bindings/phy/mediatek,tphy.yaml
@@ -235,6 +235,15 @@ patternProperties:
           Specify the flag to enable BC1.2 if support it
         type: boolean
 
+      mediatek,force-mode:
+        description:
+          The force mode is used to manually switch the shared phy mode between
+          USB3 and PCIe, when USB3 phy type is selected by the consumer, and
+          force-mode is set, will cause phy's power and pipe toggled and force
+          phy as USB3 mode which switched from default PCIe mode. But perfer to
+          use the property "mediatek,syscon-type" for newer SoCs that support it.
+        type: boolean
+
       mediatek,syscon-type:
         $ref: /schemas/types.yaml#/definitions/phandle-array
         maxItems: 1
-- 
2.18.0




More information about the linux-phy mailing list