[PATCH v3 9/9] PCI: qcom-ep: Setup PHY to work in EP mode

[Dmitry Baryshkov]

Call phy_set_mode_ext() to notify the PHY driver that the PHY is being
used in the EP mode.

Reviewed-by: Manivannan Sadhasivam <manivannan.sadhasivam at linaro.org>
Signed-off-by: Dmitry Baryshkov <dmitry.baryshkov at linaro.org>
---
 drivers/pci/controller/dwc/pcie-qcom-ep.c | 4 ++++
 1 file changed, 4 insertions(+)

diff --git a/drivers/pci/controller/dwc/pcie-qcom-ep.c b/drivers/pci/controller/dwc/pcie-qcom-ep.c
index ec99116ad05c..e2a1c3c7f599 100644
--- a/drivers/pci/controller/dwc/pcie-qcom-ep.c
+++ b/drivers/pci/controller/dwc/pcie-qcom-ep.c
@@ -240,6 +240,10 @@ static int qcom_pcie_enable_resources(struct qcom_pcie_ep *pcie_ep)
 	if (ret)
 		goto err_disable_clk;
 
+	ret = phy_set_mode_ext(pcie_ep->phy, PHY_MODE_PCIE, PHY_SUBMODE_PCIE_EP);
+	if (ret)
+		goto err_phy_exit;
+
 	ret = phy_power_on(pcie_ep->phy);
 	if (ret)
 		goto err_phy_exit;
-- 
2.35.1