[PATCH v4 8/8] arm64: dts: qcom: sm8350-hdk: enable PCIe devices

[Dmitry Baryshkov]

Enable PCIe0 and PCIe1 hosts found on SM8350 HDK board.

Signed-off-by: Dmitry Baryshkov <dmitry.baryshkov at linaro.org>
---
 arch/arm64/boot/dts/qcom/sm8350-hdk.dts | 80 +++++++++++++++++++++++++
 1 file changed, 80 insertions(+)

diff --git a/arch/arm64/boot/dts/qcom/sm8350-hdk.dts b/arch/arm64/boot/dts/qcom/sm8350-hdk.dts
index 69ae6503c2f6..bff75602303c 100644
--- a/arch/arm64/boot/dts/qcom/sm8350-hdk.dts
+++ b/arch/arm64/boot/dts/qcom/sm8350-hdk.dts
@@ -234,6 +234,39 @@ &mpss {
 	firmware-name = "qcom/sm8350/modem.mbn";
 };
 
+&pcie0 {
+	pinctrl-names = "default";
+	pinctrl-0 = <&pcie0_default_state>;
+
+	perst-gpios = <&tlmm 94 GPIO_ACTIVE_LOW>;
+	wake-gpios = <&tlmm 96 GPIO_ACTIVE_HIGH>;
+
+	status = "okay";
+};
+
+&pcie0_phy {
+	vdda-phy-supply = <&vreg_l5b_0p88>;
+	vdda-pll-supply = <&vreg_l6b_1p2>;
+
+	status = "okay";
+};
+
+&pcie1 {
+	perst-gpios = <&tlmm 97 GPIO_ACTIVE_LOW>;
+	wake-gpios = <&tlmm 99 GPIO_ACTIVE_HIGH>;
+
+	pinctrl-names = "default";
+	pinctrl-0 = <&pcie1_default_state>;
+
+	status = "okay";
+};
+
+&pcie1_phy {
+	status = "okay";
+	vdda-phy-supply = <&vreg_l5b_0p88>;
+	vdda-pll-supply = <&vreg_l6b_1p2>;
+};
+
 &qupv3_id_0 {
 	status = "okay";
 };
@@ -245,6 +278,53 @@ &slpi {
 
 &tlmm {
 	gpio-reserved-ranges = <52 8>;
+
+	pcie0_default_state: pcie0-default-state {
+		perst-pins {
+			pins = "gpio94";
+			function = "gpio";
+			drive-strength = <2>;
+			bias-pull-down;
+		};
+
+		clkreq-pins {
+			pins = "gpio95";
+			function = "pcie0_clkreqn";
+			drive-strength = <2>;
+			bias-pull-up;
+		};
+
+		wake-pins {
+			pins = "gpio96";
+			function = "gpio";
+			drive-strength = <2>;
+			bias-pull-up;
+		};
+	};
+
+	pcie1_default_state: pcie1-default-state {
+		perst-pins {
+			pins = "gpio97";
+			function = "gpio";
+			drive-strength = <2>;
+			bias-pull-down;
+		};
+
+		clkreq-pins {
+			pins = "gpio98";
+			function = "pcie1_clkreqn";
+			drive-strength = <2>;
+			bias-pull-up;
+		};
+
+		wake-pins {
+			pins = "gpio99";
+			function = "gpio";
+			drive-strength = <2>;
+			bias-pull-up;
+		};
+	};
+
 };
 
 &uart2 {
-- 
2.35.1