[PATCH v2 7/8] arm64: dts: qcom: sm8350: add PCIe devices

[Dmitry Baryshkov]

On 10/11/2022 13:53, Johan Hovold wrote:
> On Thu, Nov 10, 2022 at 01:33:44PM +0300, Dmitry Baryshkov wrote:
>> Add PCIe0 and PCIe1 (and corresponding PHY) devices found on SM8350
>> platform. The PCIe0 is a 1-lane Gen3 host, PCIe1 is a 2-lane Gen3 host.
>>
>> Signed-off-by: Dmitry Baryshkov <dmitry.baryshkov at linaro.org>
>> ---
>>   arch/arm64/boot/dts/qcom/sm8350.dtsi | 246 ++++++++++++++++++++++++++-
>>   1 file changed, 244 insertions(+), 2 deletions(-)
> 
>> @@ -1761,6 +1957,52 @@ tlmm: pinctrl at f100000 {
>>   			gpio-ranges = <&tlmm 0 0 204>;
>>   			wakeup-parent = <&pdc>;
>>   
>> +			pcie0_default_state: pcie0-default-state {
>> +				perst-pins {
>> +					pins = "gpio94";
>> +					function = "gpio";
>> +					drive-strength = <2>;
>> +					bias-pull-down;
>> +				};
>> +
>> +				clkreq-pins {
>> +					pins = "gpio95";
>> +					function = "pcie0_clkreqn";
>> +					drive-strength = <2>;
>> +					bias-pull-up;
>> +				};
>> +
>> +				wake-pins {
>> +					pins = "gpio96";
>> +					function = "gpio";
>> +					drive-strength = <2>;
>> +					bias-pull-up;
>> +				};
>> +			};
> 
> The pinconfig should go in the board file.

Usually yes. However for the PCIe we usually put them into the main 
.dtsi. See sm8[124]50.dtsi.

-- 
With best wishes
Dmitry