[PATCH v2 54/65] clk: da8xx: clk48: Switch to determine_rate

[Maxime Ripard]

Hi David,

On Fri, Nov 04, 2022 at 11:49:34AM -0500, David Lechner wrote:
> On 11/4/22 8:18 AM, Maxime Ripard wrote:
> > The TI DA8xx USB0 clk48 clocks implements a mux with a set_parent
> > hook, but doesn't provide a determine_rate implementation.
> > 
> > This is a bit odd, since set_parent() is there to, as its name implies,
> > change the parent of a clock. However, the most likely candidate to
> > trigger that parent change is a call to clk_set_rate(), with
> > determine_rate() figuring out which parent is the best suited for a
> > given rate.
> > 
> > The other trigger would be a call to clk_set_parent(), but it's far less
> > used, and it doesn't look like there's any obvious user for that clock.
> > 
> > So, the set_parent hook is effectively unused, possibly because of an
> > oversight. However, it could also be an explicit decision by the
> > original author to avoid any reparenting but through an explicit call to
> > clk_set_parent().
> > 
> > The driver does implement round_rate() though, which means that we can
> > change the rate of the clock, but we will never get to change the
> > parent.
> > 
> > However, It's hard to tell whether it's been done on purpose or not.
> > 
> > Since we'll start mandating a determine_rate() implementation, let's
> > convert the round_rate() implementation to a determine_rate(), which
> > will also make the current behavior explicit. And if it was an
> > oversight, the clock behaviour can be adjusted later on.
> 
> I think this one should be the same as the clk:davinci changes and
> not allow re-parenting. Since this is a USB 48MHz PHY clock, a rate
> change will never be requested.

I'm not sure, it doesn't seem to be the same clock, it's not doing the
same thing (this one will always force the same rate, the others let the
rate change), and we're not doing the same refactoring (this one had a
round_rate implementation, the other one doesn't)

Maxime
-------------- next part --------------
A non-text attachment was scrubbed...
Name: signature.asc
Type: application/pgp-signature
Size: 228 bytes
Desc: not available
URL: <http://lists.infradead.org/pipermail/linux-phy/attachments/20221107/c5d07151/attachment.sig>