[PATCH v4 09/16] phy: qcom-qmp-pcie: add register init helper

Vinod Koul vkoul at kernel.org
Sat Nov 5 05:08:54 PDT 2022


On 28-10-22, 15:35, Johan Hovold wrote:
> Generalise the serdes initialisation helper so that it can be used to
> initialise all the PHY registers (e.g. serdes, tx, rx, pcs).
> 
> Note that this defers the ungating of the PIPE clock somewhat, which is
> fine as it isn't needed until starting the PHY.
> 
> Signed-off-by: Johan Hovold <johan+linaro at kernel.org>
> ---
>  drivers/phy/qualcomm/phy-qcom-qmp-pcie.c | 37 +++++-------------------
>  1 file changed, 8 insertions(+), 29 deletions(-)
> 
> diff --git a/drivers/phy/qualcomm/phy-qcom-qmp-pcie.c b/drivers/phy/qualcomm/phy-qcom-qmp-pcie.c
> index 791ed7ef0eab..f57d10f20277 100644
> --- a/drivers/phy/qualcomm/phy-qcom-qmp-pcie.c
> +++ b/drivers/phy/qualcomm/phy-qcom-qmp-pcie.c
> @@ -1820,27 +1820,22 @@ static void qmp_pcie_configure(void __iomem *base,
>  	qmp_pcie_configure_lane(base, tbl, num, 0xff);
>  }
>  
> -static void qmp_pcie_serdes_init(struct qmp_pcie *qmp, const struct qmp_phy_cfg_tables *tbls)
> -{
> -	void __iomem *serdes = qmp->serdes;
> -
> -	if (!tbls)
> -		return;
> -
> -	qmp_pcie_configure(serdes, tbls->serdes, tbls->serdes_num);
> -}
> -
> -static void qmp_pcie_lanes_init(struct qmp_pcie *qmp, const struct qmp_phy_cfg_tables *tbls)
> +static void qmp_pcie_init_registers(struct qmp_pcie *qmp, const struct qmp_phy_cfg_tables *tbls)
>  {
>  	const struct qmp_phy_cfg *cfg = qmp->cfg;
> +	void __iomem *serdes = qmp->serdes;
>  	void __iomem *tx = qmp->tx;
>  	void __iomem *rx = qmp->rx;
>  	void __iomem *tx2 = qmp->tx2;
>  	void __iomem *rx2 = qmp->rx2;
> +	void __iomem *pcs = qmp->pcs;
> +	void __iomem *pcs_misc = qmp->pcs_misc;
>  
>  	if (!tbls)
>  		return;
>  
> +	qmp_pcie_configure(serdes, tbls->serdes, tbls->serdes_num);

We are tbls

> +
>  	qmp_pcie_configure_lane(tx, tbls->tx, tbls->tx_num, 1);
>  	qmp_pcie_configure_lane(rx, tbls->rx, tbls->rx_num, 1);
>  
> @@ -1848,15 +1843,6 @@ static void qmp_pcie_lanes_init(struct qmp_pcie *qmp, const struct qmp_phy_cfg_t
>  		qmp_pcie_configure_lane(tx2, tbls->tx, tbls->tx_num, 2);
>  		qmp_pcie_configure_lane(rx2, tbls->rx, tbls->rx_num, 2);
>  	}
> -}
> -
> -static void qmp_pcie_pcs_init(struct qmp_pcie *qmp, const struct qmp_phy_cfg_tables *tbls)
> -{
> -	void __iomem *pcs = qmp->pcs;
> -	void __iomem *pcs_misc = qmp->pcs_misc;
> -
> -	if (!tbls)
> -		return;
>  
>  	qmp_pcie_configure(pcs, tbls->pcs, tbls->pcs_num);
>  	qmp_pcie_configure(pcs_misc, tbls->pcs_misc, tbls->pcs_misc_num);
> @@ -1932,8 +1918,8 @@ static int qmp_pcie_power_on(struct phy *phy)
>  	else
>  		mode_tables = cfg->tables_ep;
>  
> -	qmp_pcie_serdes_init(qmp, &cfg->tables);
> -	qmp_pcie_serdes_init(qmp, mode_tables);
> +	qmp_pcie_init_registers(qmp, &cfg->tables);
> +	qmp_pcie_init_registers(qmp, mode_tables);

but here tables :(

Lets stick with either please, or if we have differentiation lets make
it real obvious

>  
>  	ret = clk_prepare_enable(qmp->pipe_clk);
>  	if (ret) {
> @@ -1941,13 +1927,6 @@ static int qmp_pcie_power_on(struct phy *phy)
>  		return ret;
>  	}
>  
> -	/* Tx, Rx, and PCS configurations */
> -	qmp_pcie_lanes_init(qmp, &cfg->tables);
> -	qmp_pcie_lanes_init(qmp, mode_tables);
> -
> -	qmp_pcie_pcs_init(qmp, &cfg->tables);
> -	qmp_pcie_pcs_init(qmp, mode_tables);
> -
>  	/* Pull PHY out of reset state */
>  	qphy_clrbits(pcs, cfg->regs[QPHY_SW_RESET], SW_RESET);
>  
> -- 
> 2.37.3

-- 
~Vinod



More information about the linux-phy mailing list