[PATCH v7 2/3] phy: qcom-snps: Add support for overriding phy tuning parameters

Krishna Kurapati PSSNV quic_kriskura at quicinc.com
Tue May 31 23:31:54 PDT 2022


On 6/1/2022 7:38 AM, Pavan Kondeti wrote:
> On Tue, May 31, 2022 at 09:44:52PM +0530, Krishna Kurapati wrote:
>> Add support for overriding electrical signal tuning parameters for
>> SNPS HS Phy.
>>
>> Signed-off-by: Krishna Kurapati <quic_kriskura at quicinc.com>
>> ---
>>   drivers/phy/qualcomm/phy-qcom-snps-femto-v2.c | 268 +++++++++++++++++++++++++-
>>   1 file changed, 266 insertions(+), 2 deletions(-)
>>
>> diff --git a/drivers/phy/qualcomm/phy-qcom-snps-femto-v2.c b/drivers/phy/qualcomm/phy-qcom-snps-femto-v2.c
>> index 5d20378..3a17216 100644
>> --- a/drivers/phy/qualcomm/phy-qcom-snps-femto-v2.c
>> +++ b/drivers/phy/qualcomm/phy-qcom-snps-femto-v2.c
>> @@ -52,6 +52,12 @@
>>   #define USB2_SUSPEND_N				BIT(2)
>>   #define USB2_SUSPEND_N_SEL			BIT(3)
>>   
> <snip>
>
>> +static void qcom_snps_hsphy_override_param_update_val(
>> +			const struct override_param_map map,
>> +			s32 dt_val, struct phy_override_seq *seq_entry)
>> +{
>> +	int i;
>> +
>> +	/*
>> +	 * Param table for each param is in increasing order
>> +	 * of dt values. We need to iterate over the list to
>> +	 * select the entry that has equal or the next highest value.
>> +	 */
>> +	for (i = 0; i < map.table_size - 1; i++) {
>> +		if (map.param_table[i].value >= dt_val)
>> +			break;
>> +	}
>> +
>> +	seq_entry->need_update = true;
>> +	seq_entry->offset = map.reg_offset;
>> +	seq_entry->mask = map.param_mask;
>> +	seq_entry->value =  map.param_table[i].reg << __ffs(map.param_mask);
>> +}
>> +
>> +static void qcom_snps_hsphy_read_override_param_seq(struct device *dev)
>> +{
>> +	struct device_node *node = dev->of_node;
>> +	s32 val;
>> +	int ret, i;
>> +	struct qcom_snps_hsphy *hsphy;
>> +	const struct override_param_map *cfg =
>> +		(struct override_param_map *) of_device_get_match_data(dev);
> As mentioned in the previous patch-set, the explicit typecast is not needed.
>
> overall, looks good to me. After fixing the above, feel free to use
>
> Reviewed-by: Pavankumar Kondeti <quic_pkondeti at quicinc.com>
>
> Thanks,
> Pavan
My bad, Thanks for the review Pavan. Will fix it in the next patch.



More information about the linux-phy mailing list