[RFC PATCH 25/28] phy: qcom-qmp: pcs-v3: add missing registers
Dmitry Baryshkov
dmitry.baryshkov at linaro.org
Fri Jun 10 12:09:22 PDT 2022
Add missing registers, verified against:
- msm-4.19's qcom,usb3-11nm-qmp-combo.h
Signed-off-by: Dmitry Baryshkov <dmitry.baryshkov at linaro.org>
---
drivers/phy/qualcomm/phy-qcom-qmp-pcs-v3.h | 82 ++++++++++++++++++++++
1 file changed, 82 insertions(+)
diff --git a/drivers/phy/qualcomm/phy-qcom-qmp-pcs-v3.h b/drivers/phy/qualcomm/phy-qcom-qmp-pcs-v3.h
index ac13f2989a73..10dbbb006201 100644
--- a/drivers/phy/qualcomm/phy-qcom-qmp-pcs-v3.h
+++ b/drivers/phy/qualcomm/phy-qcom-qmp-pcs-v3.h
@@ -7,7 +7,9 @@
#define QCOM_PHY_QMP_PCS_V3_H_
/* Only for QMP V3 PHY - PCS registers */
+#define QPHY_V3_PCS_SW_RESET 0x000
#define QPHY_V3_PCS_POWER_DOWN_CONTROL 0x004
+#define QPHY_V3_PCS_START_CONTROL 0x008
#define QPHY_V3_PCS_TXMGN_V0 0x00c
#define QPHY_V3_PCS_TXMGN_V1 0x010
#define QPHY_V3_PCS_TXMGN_V2 0x014
@@ -31,6 +33,7 @@
#define QPHY_V3_PCS_RATE_SLEW_CNTRL 0x05c
#define QPHY_V3_PCS_POWER_STATE_CONFIG1 0x060
#define QPHY_V3_PCS_POWER_STATE_CONFIG2 0x064
+#define QPHY_V3_PCS_POWER_STATE_CONFIG3 0x068
#define QPHY_V3_PCS_POWER_STATE_CONFIG4 0x06c
#define QPHY_V3_PCS_RCVR_DTCT_DLY_P1U2_L 0x070
#define QPHY_V3_PCS_RCVR_DTCT_DLY_P1U2_H 0x074
@@ -40,24 +43,103 @@
#define QPHY_V3_PCS_LOCK_DETECT_CONFIG2 0x084
#define QPHY_V3_PCS_LOCK_DETECT_CONFIG3 0x088
#define QPHY_V3_PCS_TSYNC_RSYNC_TIME 0x08c
+#define QPHY_V3_PCS_SIGDET_LOW_2_IDLE_TIME 0x090
+#define QPHY_V3_PCS_BEACON_2_IDLE_TIME_L 0x094
+#define QPHY_V3_PCS_BEACON_2_IDLE_TIME_H 0x098
+#define QPHY_V3_PCS_PWRUP_RESET_DLY_TIME_SYSCLK 0x09c
#define QPHY_V3_PCS_PWRUP_RESET_DLY_TIME_AUXCLK 0x0a0
#define QPHY_V3_PCS_LP_WAKEUP_DLY_TIME_AUXCLK 0x0a4
#define QPHY_V3_PCS_PLL_LOCK_CHK_DLY_TIME 0x0a8
+#define QPHY_V3_PCS_LFPS_DET_HIGH_COUNT_VAL 0x0ac
#define QPHY_V3_PCS_LFPS_TX_ECSTART_EQTLOCK 0x0b0
+#define QPHY_V3_PCS_LFPS_TX_END_CNT_P2U3_START 0x0b4
#define QPHY_V3_PCS_RXEQTRAINING_WAIT_TIME 0x0b8
#define QPHY_V3_PCS_RXEQTRAINING_RUN_TIME 0x0bc
+#define QPHY_V3_PCS_TXONESZEROS_RUN_LENGTH 0x0c0
#define QPHY_V3_PCS_FLL_CNTRL1 0x0c4
#define QPHY_V3_PCS_FLL_CNTRL2 0x0c8
#define QPHY_V3_PCS_FLL_CNT_VAL_L 0x0cc
#define QPHY_V3_PCS_FLL_CNT_VAL_H_TOL 0x0d0
#define QPHY_V3_PCS_FLL_MAN_CODE 0x0d4
+#define QPHY_V3_PCS_AUTONOMOUS_MODE_CTRL 0x0d8
+#define QPHY_V3_PCS_LFPS_RXTERM_IRQ_CLEAR 0x0dc
+#define QPHY_V3_PCS_ARCVR_DTCT_EN_PERIOD 0x0e0
+#define QPHY_V3_PCS_ARCVR_DTCT_CM_DLY 0x0e4
+#define QPHY_V3_PCS_ALFPS_DEGLITCH_VAL 0x0e8
+#define QPHY_V3_PCS_INSIG_SW_CTRL1 0x0ec
+#define QPHY_V3_PCS_INSIG_SW_CTRL2 0x0f0
+#define QPHY_V3_PCS_INSIG_SW_CTRL3 0x0f4
+#define QPHY_V3_PCS_INSIG_MX_CTRL1 0x0f8
+#define QPHY_V3_PCS_INSIG_MX_CTRL2 0x0fc
+#define QPHY_V3_PCS_INSIG_MX_CTRL3 0x100
+#define QPHY_V3_PCS_OUTSIG_SW_CTRL1 0x104
+#define QPHY_V3_PCS_OUTSIG_MX_CTRL1 0x108
+#define QPHY_V3_PCS_CLK_DEBUG_BYPASS_CTRL 0x10c
+#define QPHY_V3_PCS_TEST_CONTROL 0x110
+#define QPHY_V3_PCS_TEST_CONTROL2 0x114
+#define QPHY_V3_PCS_TEST_CONTROL3 0x118
+#define QPHY_V3_PCS_TEST_CONTROL4 0x11c
+#define QPHY_V3_PCS_TEST_CONTROL5 0x120
+#define QPHY_V3_PCS_TEST_CONTROL6 0x124
+#define QPHY_V3_PCS_TEST_CONTROL7 0x128
+#define QPHY_V3_PCS_COM_RESET_CONTROL 0x12c
+#define QPHY_V3_PCS_BIST_CTRL 0x130
+#define QPHY_V3_PCS_PRBS_POLY0 0x134
+#define QPHY_V3_PCS_PRBS_POLY1 0x138
+#define QPHY_V3_PCS_PRBS_SEED0 0x13c
+#define QPHY_V3_PCS_PRBS_SEED1 0x140
+#define QPHY_V3_PCS_FIXED_PAT_CTRL 0x144
+#define QPHY_V3_PCS_FIXED_PAT0 0x148
+#define QPHY_V3_PCS_FIXED_PAT1 0x14c
+#define QPHY_V3_PCS_FIXED_PAT2 0x150
+#define QPHY_V3_PCS_FIXED_PAT3 0x154
+#define QPHY_V3_PCS_COM_CLK_SWITCH_CTRL 0x158
+#define QPHY_V3_PCS_ELECIDLE_DLY_SEL 0x15c
+#define QPHY_V3_PCS_SPARE1 0x160
+#define QPHY_V3_PCS_BIST_CHK_ERR_CNT_L_STATUS 0x164
+#define QPHY_V3_PCS_BIST_CHK_ERR_CNT_H_STATUS 0x168
+#define QPHY_V3_PCS_BIST_CHK_STATUS 0x16c
+#define QPHY_V3_PCS_LFPS_RXTERM_IRQ_SOURCE_STATUS 0x170
+#define QPHY_V3_PCS_PCS_STATUS 0x174
+#define QPHY_V3_PCS_PCS_STATUS2 0x178
+#define QPHY_V3_PCS_PCS_STATUS3 0x17c
+#define QPHY_V3_PCS_COM_RESET_STATUS 0x180
+#define QPHY_V3_PCS_OSC_DTCT_STATUS 0x184
+#define QPHY_V3_PCS_REVISION_ID0 0x188
+#define QPHY_V3_PCS_REVISION_ID1 0x18c
+#define QPHY_V3_PCS_REVISION_ID2 0x190
+#define QPHY_V3_PCS_REVISION_ID3 0x194
+#define QPHY_V3_PCS_DEBUG_BUS_0_STATUS 0x198
+#define QPHY_V3_PCS_DEBUG_BUS_1_STATUS 0x19c
+#define QPHY_V3_PCS_DEBUG_BUS_2_STATUS 0x1a0
+#define QPHY_V3_PCS_DEBUG_BUS_3_STATUS 0x1a4
#define QPHY_V3_PCS_LP_WAKEUP_DLY_TIME_AUXCLK_MSB 0x1a8
#define QPHY_V3_PCS_OSC_DTCT_ACTIONS 0x1ac
#define QPHY_V3_PCS_SIGDET_CNTRL 0x1b0
+#define QPHY_V3_PCS_IDAC_CAL_CNTRL 0x1b4
+#define QPHY_V3_PCS_CMN_ACK_OUT_SEL 0x1b8
+#define QPHY_V3_PCS_PLL_LOCK_CHK_DLY_TIME_SYSCLK 0x1bc
+#define QPHY_V3_PCS_AUTONOMOUS_MODE_STATUS 0x1c0
+#define QPHY_V3_PCS_ENDPOINT_REFCLK_CNTRL 0x1c4
+#define QPHY_V3_PCS_EPCLK_PRE_PLL_LOCK_DLY_SYSCLK 0x1c8
+#define QPHY_V3_PCS_EPCLK_PRE_PLL_LOCK_DLY_AUXCLK 0x1cc
+#define QPHY_V3_PCS_EPCLK_DLY_COUNT_VAL_L 0x1d0
+#define QPHY_V3_PCS_EPCLK_DLY_COUNT_VAL_H 0x1d4
#define QPHY_V3_PCS_RX_SIGDET_LVL 0x1d8
#define QPHY_V3_PCS_L1SS_WAKEUP_DLY_TIME_AUXCLK_LSB 0x1dc
#define QPHY_V3_PCS_L1SS_WAKEUP_DLY_TIME_AUXCLK_MSB 0x1e0
+#define QPHY_V3_PCS_AUTONOMOUS_MODE_CTRL2 0x1e4
+#define QPHY_V3_PCS_RXTERMINATION_DLY_SEL 0x1e8
+#define QPHY_V3_PCS_LFPS_PER_TIMER_VAL 0x1ec
+#define QPHY_V3_PCS_SIGDET_STARTUP_TIMER_VAL 0x1f0
+#define QPHY_V3_PCS_LOCK_DETECT_CONFIG4 0x1f4
+#define QPHY_V3_PCS_RX_SIGDET_DTCT_CNTRL 0x1f8
+#define QPHY_V3_PCS_PCS_STATUS4 0x1fc
+#define QPHY_V3_PCS_PCS_STATUS4_CLEAR 0x200
+#define QPHY_V3_PCS_DEC_ERROR_COUNT_STATUS 0x204
+#define QPHY_V3_PCS_COMMA_POS_STATUS 0x208
#define QPHY_V3_PCS_REFGEN_REQ_CONFIG1 0x20c
#define QPHY_V3_PCS_REFGEN_REQ_CONFIG2 0x210
+#define QPHY_V3_PCS_REFGEN_REQ_CONFIG3 0x214
#endif
--
2.35.1
More information about the linux-phy
mailing list