[PATCH v2 1/6] dt-bindings: phy: samsung,ufs-phy: make pmu-syscon as phandle-array
Krzysztof Kozlowski
krzysztof.kozlowski at linaro.org
Thu Jun 2 04:42:22 PDT 2022
On 02/06/2022 12:10, Chanho Park wrote:
>>>> samsung,pmu-syscon:
>>>> - $ref: '/schemas/types.yaml#/definitions/phandle'
>>>> - description: phandle for PMU system controller interface, used to
>>>> - control pmu registers bits for ufs m-phy
>>>> + $ref: '/schemas/types.yaml#/definitions/phandle-array'
>>>> + items:
>>>> + minItems: 1
>>>> + items:
>>>> + - description: phandle for PMU system controller interface, used
>> to
>>>> + control pmu registers bits for ufs m-phy
>>>> + - description: offset of the pmu control register
>>>
>>> This does not work... Please test your bindings with different cases.
>>
>> Just to be clear - when I mentioned that minItems should be on second
>> items level, I meant it should affect the second items list, not the first.
>> Now you can have 1, 2 or 10 phandles.
>
> I put the minItems to the second level as you mentioned but I got below error from dt_binding_check.
>
> --- a/Documentation/devicetree/bindings/phy/samsung,ufs-phy.yaml
> +++ b/Documentation/devicetree/bindings/phy/samsung,ufs-phy.yaml
> @@ -42,8 +42,8 @@ properties:
> samsung,pmu-syscon:
> $ref: '/schemas/types.yaml#/definitions/phandle-array'
> items:
> - minItems: 1
> items:
> + - minItems: 1
Ah, you are right. This above is not good, but your original code was
almost good. I think it should be:
43 $ref: '/schemas/types.yaml#/definitions/phandle-array'
44 maxItems: 1
45 items:
46 minItems: 1
47 items:
48 - description: phandle for PMU sysused to
50 - description: offset of the pmu control register
Apologies for the confusion.
> - description: phandle for PMU system controller interface, used to
> control pmu registers bits for ufs m-phy
> - description: offset of the pmu control register
>
> $ make dt_binding_check DT_SCHEMA_FILES=Documentation/devicetree/bindings/phy/samsung,ufs-phy.yaml
> ufs-phy at 15571800: samsung,pmu-syscon:0: [4294967295, 1828] is too short
Best regards,
Krzysztof
More information about the linux-phy
mailing list