[PATCH 2/3] phy: rockchip: add support for the rk356x variant to rockchip-inno-csidphy
Michael Riesch
michael.riesch at wolfvision.net
Wed Jul 20 02:15:26 PDT 2022
This adds support for variant found in Rockchip RK356x SoCs. Note that
only the basic operating mode is supported, in which all four CSI lines
are controlled by the Rockchip ISP.
Signed-off-by: Michael Riesch <michael.riesch at wolfvision.net>
---
.../phy/rockchip/phy-rockchip-inno-csidphy.c | 24 +++++++++++++++++++
1 file changed, 24 insertions(+)
diff --git a/drivers/phy/rockchip/phy-rockchip-inno-csidphy.c b/drivers/phy/rockchip/phy-rockchip-inno-csidphy.c
index ca13a604ab4f..75f948bdea6a 100644
--- a/drivers/phy/rockchip/phy-rockchip-inno-csidphy.c
+++ b/drivers/phy/rockchip/phy-rockchip-inno-csidphy.c
@@ -27,6 +27,9 @@
#define RK3368_GRF_SOC_CON6_OFFSET 0x0418
+#define RK3568_GRF_VI_CON0 0x0340
+#define RK3568_GRF_VI_CON1 0x0344
+
/* PHY */
#define CSIDPHY_CTRL_LANE_ENABLE 0x00
#define CSIDPHY_CTRL_LANE_ENABLE_CK BIT(6)
@@ -58,9 +61,11 @@
#define RK1808_CSIDPHY_CLK_WR_THS_SETTLE 0x160
#define RK3326_CSIDPHY_CLK_WR_THS_SETTLE 0x100
#define RK3368_CSIDPHY_CLK_WR_THS_SETTLE 0x100
+#define RK3568_CSIDPHY_CLK_WR_THS_SETTLE 0x160
/* Calibration reception enable */
#define RK1808_CSIDPHY_CLK_CALIB_EN 0x168
+#define RK3568_CSIDPHY_CLK_CALIB_EN 0x168
/*
* The higher 16-bit of this register is used for write protection
@@ -103,6 +108,12 @@ static const struct dphy_reg rk3368_grf_dphy_regs[] = {
[GRF_DPHY_CSIPHY_FORCERXMODE] = PHY_REG(RK3368_GRF_SOC_CON6_OFFSET, 4, 8),
};
+static const struct dphy_reg rk3568_grf_dphy_regs[] = {
+ [GRF_DPHY_CSIPHY_FORCERXMODE] = PHY_REG(RK3568_GRF_VI_CON0, 4, 0),
+ [GRF_DPHY_CSIPHY_DATALANE_EN] = PHY_REG(RK3568_GRF_VI_CON0, 4, 4),
+ [GRF_DPHY_CSIPHY_CLKLANE_EN] = PHY_REG(RK3568_GRF_VI_CON0, 1, 8),
+};
+
struct hsfreq_range {
u32 range_h;
u8 cfg_bit;
@@ -352,6 +363,15 @@ static const struct dphy_drv_data rk3368_mipidphy_drv_data = {
.grf_regs = rk3368_grf_dphy_regs,
};
+static const struct dphy_drv_data rk3568_mipidphy_drv_data = {
+ .pwrctl_offset = -1,
+ .ths_settle_offset = RK3568_CSIDPHY_CLK_WR_THS_SETTLE,
+ .calib_offset = RK3568_CSIDPHY_CLK_CALIB_EN,
+ .hsfreq_ranges = rk1808_mipidphy_hsfreq_ranges,
+ .num_hsfreq_ranges = ARRAY_SIZE(rk1808_mipidphy_hsfreq_ranges),
+ .grf_regs = rk3568_grf_dphy_regs,
+};
+
static const struct of_device_id rockchip_inno_csidphy_match_id[] = {
{
.compatible = "rockchip,px30-csi-dphy",
@@ -369,6 +389,10 @@ static const struct of_device_id rockchip_inno_csidphy_match_id[] = {
.compatible = "rockchip,rk3368-csi-dphy",
.data = &rk3368_mipidphy_drv_data,
},
+ {
+ .compatible = "rockchip,rk3568-csi-dphy",
+ .data = &rk3568_mipidphy_drv_data,
+ },
{}
};
MODULE_DEVICE_TABLE(of, rockchip_inno_csidphy_match_id);
--
2.30.2
More information about the linux-phy
mailing list