[PATCH v8 05/19] drm/mediatek: dpi: move dpi limits to board config

Guillaume Ranquet granquet at baylibre.com
Fri Feb 25 02:45:43 PST 2022


Quoting Chun-Kuang Hu (2022-02-21 02:46:15)
> Hi, Guillaume:
>
> Guillaume Ranquet <granquet at baylibre.com> 於 2022年2月18日 週五 下午10:56寫道:
> >
> > Add flexibility by moving the dpi limits to the board config
>
> This patch looks good to me. But I would like to know what's this
> limit and why it vary in different SoC. If possible, would you please
> provide more description for this?
>
> Regards,
> Chun-Kuang.
>

Hi Chun-Kuang,

You are right, the commit message is rather vague and deserves more details.
I'll have to dig into the documentations I have access to and ask maybe ask
the engineers at mediatek for a detailed description.

Thx,
Guillaume.

> >
> > Signed-off-by: Guillaume Ranquet <granquet at baylibre.com>
> > ---
> >  drivers/gpu/drm/mediatek/mtk_dpi.c | 25 ++++++++++++++++---------
> >  1 file changed, 16 insertions(+), 9 deletions(-)
> >
> > diff --git a/drivers/gpu/drm/mediatek/mtk_dpi.c b/drivers/gpu/drm/mediatek/mtk_dpi.c
> > index 4554e2de14309..4746eb3425674 100644
> > --- a/drivers/gpu/drm/mediatek/mtk_dpi.c
> > +++ b/drivers/gpu/drm/mediatek/mtk_dpi.c
> > @@ -125,6 +125,7 @@ struct mtk_dpi_conf {
> >         bool edge_sel_en;
> >         const u32 *output_fmts;
> >         u32 num_output_fmts;
> > +       const struct mtk_dpi_yc_limit *limit;
> >  };
> >
> >  static void mtk_dpi_mask(struct mtk_dpi *dpi, u32 offset, u32 val, u32 mask)
> > @@ -235,9 +236,10 @@ static void mtk_dpi_config_fb_size(struct mtk_dpi *dpi, u32 width, u32 height)
> >         mtk_dpi_mask(dpi, DPI_SIZE, height << VSIZE, VSIZE_MASK);
> >  }
> >
> > -static void mtk_dpi_config_channel_limit(struct mtk_dpi *dpi,
> > -                                        struct mtk_dpi_yc_limit *limit)
> > +static void mtk_dpi_config_channel_limit(struct mtk_dpi *dpi)
> >  {
> > +       const struct mtk_dpi_yc_limit *limit = dpi->conf->limit;
> > +
> >         mtk_dpi_mask(dpi, DPI_Y_LIMIT, limit->y_bottom << Y_LIMINT_BOT,
> >                      Y_LIMINT_BOT_MASK);
> >         mtk_dpi_mask(dpi, DPI_Y_LIMIT, limit->y_top << Y_LIMINT_TOP,
> > @@ -449,7 +451,6 @@ static int mtk_dpi_power_on(struct mtk_dpi *dpi)
> >  static int mtk_dpi_set_display_mode(struct mtk_dpi *dpi,
> >                                     struct drm_display_mode *mode)
> >  {
> > -       struct mtk_dpi_yc_limit limit;
> >         struct mtk_dpi_polarities dpi_pol;
> >         struct mtk_dpi_sync_param hsync;
> >         struct mtk_dpi_sync_param vsync_lodd = { 0 };
> > @@ -484,11 +485,6 @@ static int mtk_dpi_set_display_mode(struct mtk_dpi *dpi,
> >         dev_dbg(dpi->dev, "Got  PLL %lu Hz, pixel clock %lu Hz\n",
> >                 pll_rate, vm.pixelclock);
> >
> > -       limit.c_bottom = 0x0010;
> > -       limit.c_top = 0x0FE0;
> > -       limit.y_bottom = 0x0010;
> > -       limit.y_top = 0x0FE0;
> > -
> >         dpi_pol.ck_pol = MTK_DPI_POLARITY_FALLING;
> >         dpi_pol.de_pol = MTK_DPI_POLARITY_RISING;
> >         dpi_pol.hsync_pol = vm.flags & DISPLAY_FLAGS_HSYNC_HIGH ?
> > @@ -536,7 +532,7 @@ static int mtk_dpi_set_display_mode(struct mtk_dpi *dpi,
> >         else
> >                 mtk_dpi_config_fb_size(dpi, vm.hactive, vm.vactive);
> >
> > -       mtk_dpi_config_channel_limit(dpi, &limit);
> > +       mtk_dpi_config_channel_limit(dpi);
> >         mtk_dpi_config_bit_num(dpi, dpi->bit_num);
> >         mtk_dpi_config_channel_swap(dpi, dpi->channel_swap);
> >         mtk_dpi_config_yc_map(dpi, dpi->yc_map);
> > @@ -790,12 +786,20 @@ static const u32 mt8183_output_fmts[] = {
> >         MEDIA_BUS_FMT_RGB888_2X12_BE,
> >  };
> >
> > +static const struct mtk_dpi_yc_limit mtk_dpi_limit = {
> > +       .c_bottom = 0x0010,
> > +       .c_top = 0x0FE0,
> > +       .y_bottom = 0x0010,
> > +       .y_top = 0x0FE0,
> > +};
> > +
> >  static const struct mtk_dpi_conf mt8173_conf = {
> >         .cal_factor = mt8173_calculate_factor,
> >         .reg_h_fre_con = 0xe0,
> >         .max_clock_khz = 300000,
> >         .output_fmts = mt8173_output_fmts,
> >         .num_output_fmts = ARRAY_SIZE(mt8173_output_fmts),
> > +       .limit = &mtk_dpi_limit,
> >  };
> >
> >  static const struct mtk_dpi_conf mt2701_conf = {
> > @@ -805,6 +809,7 @@ static const struct mtk_dpi_conf mt2701_conf = {
> >         .max_clock_khz = 150000,
> >         .output_fmts = mt8173_output_fmts,
> >         .num_output_fmts = ARRAY_SIZE(mt8173_output_fmts),
> > +       .limit = &mtk_dpi_limit,
> >  };
> >
> >  static const struct mtk_dpi_conf mt8183_conf = {
> > @@ -813,6 +818,7 @@ static const struct mtk_dpi_conf mt8183_conf = {
> >         .max_clock_khz = 100000,
> >         .output_fmts = mt8183_output_fmts,
> >         .num_output_fmts = ARRAY_SIZE(mt8183_output_fmts),
> > +       .limit = &mtk_dpi_limit,
> >  };
> >
> >  static const struct mtk_dpi_conf mt8192_conf = {
> > @@ -821,6 +827,7 @@ static const struct mtk_dpi_conf mt8192_conf = {
> >         .max_clock_khz = 150000,
> >         .output_fmts = mt8173_output_fmts,
> >         .num_output_fmts = ARRAY_SIZE(mt8173_output_fmts),
> > +       .limit = &mtk_dpi_limit,
> >  };
> >
> >  static int mtk_dpi_probe(struct platform_device *pdev)
> > --
> > 2.34.1
> >



More information about the linux-phy mailing list