[PATCH 0/9] usb/dwc3 / phy/tusb1210: Add TUSB1211 charger detection

[Hans de Goede]

Some Android x86 tablets with a Bay Trail (BYT) SoC (with DWC3 UDC)
and a Crystal Cove PMIC, which does not support charger-detection,
rely on a TUSB1211 phy for charger-detection.

This series adds support for this, it starts with some dwc3 bug-fixes
for issues hit while developing this, as well as adding support to
the dwc3 code to set a special property checked by the tusb1210 driver
to signal that it needs to enable charger-detection.

The 2nd half of the series does some refactoring / fixes to the
tusb1210 driver and adds the charger-detection support.

Regards,

Hans


Hans de Goede (8):
  usb: dwc3: pci: Add "snps,dis_u2_susphy_quirk" for Intel Bay Trail
  usb: dwc3: pci: Fix Bay Trail phy GPIO mappings
  usb: dwc3: pci: Set the swnode from inside dwc3_pci_quirks()
  usb: dwc3: pci: Set "linux,phy_charger_detect" property on some Bay
    Trail boards
  usb: dwc3: pci: Also apply Bay Trail GPIO mappings to ulpi-device
  phy: ti: tusb1210: Improve ulpi_read()/_write() error checking
  phy: ti: tusb1210: Drop tusb->vendor_specific2 != 0 check from
    tusb1210_power_on()
  phy: ti: tusb1210: Add a delay between power-on and restoring the
    phy-parameters

Stephan Gerhold (1):
  phy: ti: tusb1210: Add charger detection

 drivers/phy/ti/phy-tusb1210.c | 387 ++++++++++++++++++++++++++++++++--
 drivers/usb/dwc3/dwc3-pci.c   |  60 +++++-
 2 files changed, 415 insertions(+), 32 deletions(-)

-- 
2.33.1