[PATCH v2 2/2] phy: qcom-usb-hs: Add qcom,dp-manual-pullup logic

[Stephan Gerhold]

On Thu, Dec 29, 2022 at 09:20:03PM +0000, Bryan O'Donoghue wrote:
> On 29/12/2022 21:11, Stephan Gerhold wrote:
> > Then it doesn't seem to be a particularly complete schematic. 😄
> > PM8916 definitely has USB_IN pads (pad # N13, P13). 😄
> 
> Let me check again.
> 
> No sorry USB_IN_0 and USB_IN_1 are connected to +5V in my schematic, I did
> check USB_IN I just forgot why it wasn't usable... +5v not VBUS is what its
> connected to.
> 

That is still good enough to replace qcom,dp-manual-pullup though.

If you have +5V connected to USB_IN then &pm8916_usbin should report
active VBUS permanently. Set it as extcon for &usb and &usb_hs_phy and
you should have VBUSVLDEXT "pulled-up" like in your patch here, without
any driver changes. :-)

It's a bit of a hack of course, which probably deserves a comment in the
device tree. But since it should not make any functional difference
compared to this patch the approach might be easier than getting this
patch finalized & accepted.

I leave that up to you :)

Stephan