[PATCH 1/2] phy: ti: j721e-wiz: Manage TypeC lane swap if typec-gpio-dir not specified

[Sinthu Raja]

It's possible that the Type-C plug orientation on the DIR line will be
implemented through hardware design. In that situation, there won't be
an external GPIO line available, but the driver still needs to address
this since the DT won't use the typec-gpio-dir property.

Add code to handle LN10 Type-C swap if typec-gpio-dir property is not
specified in DT.

Remove typec-gpio-dir check to use minimum debounce from Type-C spec if
it is not provided in DT

Signed-off-by: Sinthu Raja <sinthu.raja at ti.com>
---
 drivers/phy/ti/phy-j721e-wiz.c | 65 +++++++++++++++++++++-------------
 1 file changed, 40 insertions(+), 25 deletions(-)

diff --git a/drivers/phy/ti/phy-j721e-wiz.c b/drivers/phy/ti/phy-j721e-wiz.c
index 141b51af4427..b17eec632d49 100644
--- a/drivers/phy/ti/phy-j721e-wiz.c
+++ b/drivers/phy/ti/phy-j721e-wiz.c
@@ -375,6 +375,7 @@ struct wiz {
 	struct gpio_desc	*gpio_typec_dir;
 	int			typec_dir_delay;
 	u32 lane_phy_type[WIZ_MAX_LANES];
+	u32 lane_phy_reg[WIZ_MAX_LANES];
 	struct clk		*input_clks[WIZ_MAX_INPUT_CLOCKS];
 	struct clk		*output_clks[WIZ_MAX_OUTPUT_CLOCKS];
 	struct clk_onecell_data	clk_data;
@@ -1231,14 +1232,28 @@ static int wiz_phy_reset_deassert(struct reset_controller_dev *rcdev,
 	int ret;
 
 	/* if typec-dir gpio was specified, set LN10 SWAP bit based on that */
-	if (id == 0 && wiz->gpio_typec_dir) {
-		if (wiz->typec_dir_delay)
-			msleep_interruptible(wiz->typec_dir_delay);
-
-		if (gpiod_get_value_cansleep(wiz->gpio_typec_dir))
-			regmap_field_write(wiz->typec_ln10_swap, 1);
-		else
-			regmap_field_write(wiz->typec_ln10_swap, 0);
+	if (id == 0 && wiz->typec_dir_delay) {
+		msleep_interruptible(wiz->typec_dir_delay);
+
+		if (wiz->gpio_typec_dir) {
+			if (gpiod_get_value_cansleep(wiz->gpio_typec_dir))
+				regmap_field_write(wiz->typec_ln10_swap, 1);
+			else
+				regmap_field_write(wiz->typec_ln10_swap, 0);
+		} else {
+			/* if no typec-dir gpio was specified, and USB lines
+			 * are connected to Lane 0 then set LN10 SWAP bit to 1.
+			 */
+			u32 num_lanes = wiz->num_lanes;
+			int i;
+
+			for (i = 0; i < num_lanes; i++) {
+				if ((wiz->lane_phy_type[i] == PHY_TYPE_USB3) \
+						&& wiz->lane_phy_reg[i] == 0) {
+					regmap_field_write(wiz->typec_ln10_swap, 1);
+				}
+			}
+		}
 	}
 
 	if (id == 0) {
@@ -1370,8 +1385,10 @@ static int wiz_get_lane_phy_types(struct device *dev, struct wiz *wiz)
 		dev_dbg(dev, "%s: Lanes %u-%u have phy-type %u\n", __func__,
 			reg, reg + num_lanes - 1, phy_type);
 
-		for (i = reg; i < reg + num_lanes; i++)
+		for (i = reg; i < reg + num_lanes; i++) {
+			wiz->lane_phy_reg[i] = reg;
 			wiz->lane_phy_type[i] = phy_type;
+		}
 	}
 
 	return 0;
@@ -1464,24 +1481,22 @@ static int wiz_probe(struct platform_device *pdev)
 		goto err_addr_to_resource;
 	}
 
-	if (wiz->gpio_typec_dir) {
-		ret = of_property_read_u32(node, "typec-dir-debounce-ms",
-					   &wiz->typec_dir_delay);
-		if (ret && ret != -EINVAL) {
-			dev_err(dev, "Invalid typec-dir-debounce property\n");
-			goto err_addr_to_resource;
-		}
+	ret = of_property_read_u32(node, "typec-dir-debounce-ms",
+				   &wiz->typec_dir_delay);
+	if (ret && ret != -EINVAL) {
+		dev_err(dev, "Invalid typec-dir-debounce property\n");
+		goto err_addr_to_resource;
+	}
 
-		/* use min. debounce from Type-C spec if not provided in DT  */
-		if (ret == -EINVAL)
-			wiz->typec_dir_delay = WIZ_TYPEC_DIR_DEBOUNCE_MIN;
+	/* use min. debounce from Type-C spec if not provided in DT  */
+	if (ret == -EINVAL)
+		wiz->typec_dir_delay = WIZ_TYPEC_DIR_DEBOUNCE_MIN;
 
-		if (wiz->typec_dir_delay < WIZ_TYPEC_DIR_DEBOUNCE_MIN ||
-		    wiz->typec_dir_delay > WIZ_TYPEC_DIR_DEBOUNCE_MAX) {
-			ret = -EINVAL;
-			dev_err(dev, "Invalid typec-dir-debounce property\n");
-			goto err_addr_to_resource;
-		}
+	if (wiz->typec_dir_delay < WIZ_TYPEC_DIR_DEBOUNCE_MIN ||
+	    wiz->typec_dir_delay > WIZ_TYPEC_DIR_DEBOUNCE_MAX) {
+		ret = -EINVAL;
+		dev_err(dev, "Invalid typec-dir-debounce property\n");
+		goto err_addr_to_resource;
 	}
 
 	ret = wiz_get_lane_phy_types(dev, wiz);
-- 
2.36.1