[PATCH v4 15/23] scsi: ufs: ufs-qcom: Use bitfields where appropriate
Asutosh Das
quic_asutoshd at quicinc.com
Mon Dec 5 11:56:39 PST 2022
On Thu, Dec 01 2022 at 09:45 -0800, Manivannan Sadhasivam wrote:
>Use bitfield macros where appropriate to simplify the driver.
>
>Reviewed-by: Dmitry Baryshkov <dmitry.baryshkov at linaro.org>
>Signed-off-by: Manivannan Sadhasivam <manivannan.sadhasivam at linaro.org>
>---
> drivers/ufs/host/ufs-qcom.h | 61 +++++++++++++++++--------------------
> 1 file changed, 28 insertions(+), 33 deletions(-)
>
LGTM.
Reviewed-by: Asutosh Das <quic_asutoshd at quicinc.com>
>diff --git a/drivers/ufs/host/ufs-qcom.h b/drivers/ufs/host/ufs-qcom.h
>index 44466a395bb5..9d96ac71b27f 100644
>--- a/drivers/ufs/host/ufs-qcom.h
>+++ b/drivers/ufs/host/ufs-qcom.h
>@@ -17,12 +17,9 @@
> #define DEFAULT_CLK_RATE_HZ 1000000
> #define BUS_VECTOR_NAME_LEN 32
>
>-#define UFS_HW_VER_MAJOR_SHFT (28)
>-#define UFS_HW_VER_MAJOR_MASK (0x000F << UFS_HW_VER_MAJOR_SHFT)
>-#define UFS_HW_VER_MINOR_SHFT (16)
>-#define UFS_HW_VER_MINOR_MASK (0x0FFF << UFS_HW_VER_MINOR_SHFT)
>-#define UFS_HW_VER_STEP_SHFT (0)
>-#define UFS_HW_VER_STEP_MASK (0xFFFF << UFS_HW_VER_STEP_SHFT)
>+#define UFS_HW_VER_MAJOR_MASK GENMASK(31, 28)
>+#define UFS_HW_VER_MINOR_MASK GENMASK(27, 16)
>+#define UFS_HW_VER_STEP_MASK GENMASK(15, 0)
>
> /* vendor specific pre-defined parameters */
> #define SLOW 1
>@@ -76,24 +73,28 @@ enum {
> #define UFS_CNTLR_3_x_x_VEN_REGS_OFFSET(x) (0x400 + x)
>
> /* bit definitions for REG_UFS_CFG1 register */
>-#define QUNIPRO_SEL 0x1
>-#define UTP_DBG_RAMS_EN 0x20000
>+#define QUNIPRO_SEL BIT(0)
>+#define UFS_PHY_SOFT_RESET BIT(1)
>+#define UTP_DBG_RAMS_EN BIT(17)
> #define TEST_BUS_EN BIT(18)
> #define TEST_BUS_SEL GENMASK(22, 19)
> #define UFS_REG_TEST_BUS_EN BIT(30)
>
>+#define UFS_PHY_RESET_ENABLE 1
>+#define UFS_PHY_RESET_DISABLE 0
>+
> /* bit definitions for REG_UFS_CFG2 register */
>-#define UAWM_HW_CGC_EN (1 << 0)
>-#define UARM_HW_CGC_EN (1 << 1)
>-#define TXUC_HW_CGC_EN (1 << 2)
>-#define RXUC_HW_CGC_EN (1 << 3)
>-#define DFC_HW_CGC_EN (1 << 4)
>-#define TRLUT_HW_CGC_EN (1 << 5)
>-#define TMRLUT_HW_CGC_EN (1 << 6)
>-#define OCSC_HW_CGC_EN (1 << 7)
>+#define UAWM_HW_CGC_EN BIT(0)
>+#define UARM_HW_CGC_EN BIT(1)
>+#define TXUC_HW_CGC_EN BIT(2)
>+#define RXUC_HW_CGC_EN BIT(3)
>+#define DFC_HW_CGC_EN BIT(4)
>+#define TRLUT_HW_CGC_EN BIT(5)
>+#define TMRLUT_HW_CGC_EN BIT(6)
>+#define OCSC_HW_CGC_EN BIT(7)
>
> /* bit definition for UFS_UFS_TEST_BUS_CTRL_n */
>-#define TEST_BUS_SUB_SEL_MASK 0x1F /* All XXX_SEL fields are 5 bits wide */
>+#define TEST_BUS_SUB_SEL_MASK GENMASK(4, 0) /* All XXX_SEL fields are 5 bits wide */
>
> #define REG_UFS_CFG2_CGC_EN_ALL (UAWM_HW_CGC_EN | UARM_HW_CGC_EN |\
> TXUC_HW_CGC_EN | RXUC_HW_CGC_EN |\
>@@ -101,17 +102,11 @@ enum {
> TMRLUT_HW_CGC_EN | OCSC_HW_CGC_EN)
>
> /* bit offset */
>-enum {
>- OFFSET_UFS_PHY_SOFT_RESET = 1,
>- OFFSET_CLK_NS_REG = 10,
>-};
>+#define OFFSET_CLK_NS_REG 0xa
>
> /* bit masks */
>-enum {
>- MASK_UFS_PHY_SOFT_RESET = 0x2,
>- MASK_TX_SYMBOL_CLK_1US_REG = 0x3FF,
>- MASK_CLK_NS_REG = 0xFFFC00,
>-};
>+#define MASK_TX_SYMBOL_CLK_1US_REG GENMASK(9, 0)
>+#define MASK_CLK_NS_REG GENMASK(23, 10)
>
> /* QCOM UFS debug print bit mask */
> #define UFS_QCOM_DBG_PRINT_REGS_EN BIT(0)
>@@ -135,15 +130,15 @@ ufs_qcom_get_controller_revision(struct ufs_hba *hba,
> {
> u32 ver = ufshcd_readl(hba, REG_UFS_HW_VERSION);
>
>- *major = (ver & UFS_HW_VER_MAJOR_MASK) >> UFS_HW_VER_MAJOR_SHFT;
>- *minor = (ver & UFS_HW_VER_MINOR_MASK) >> UFS_HW_VER_MINOR_SHFT;
>- *step = (ver & UFS_HW_VER_STEP_MASK) >> UFS_HW_VER_STEP_SHFT;
>+ *major = FIELD_GET(UFS_HW_VER_MAJOR_MASK, ver);
>+ *minor = FIELD_GET(UFS_HW_VER_MINOR_MASK, ver);
>+ *step = FIELD_GET(UFS_HW_VER_STEP_MASK, ver);
> };
>
> static inline void ufs_qcom_assert_reset(struct ufs_hba *hba)
> {
>- ufshcd_rmwl(hba, MASK_UFS_PHY_SOFT_RESET,
>- 1 << OFFSET_UFS_PHY_SOFT_RESET, REG_UFS_CFG1);
>+ ufshcd_rmwl(hba, UFS_PHY_SOFT_RESET, FIELD_PREP(UFS_PHY_SOFT_RESET, UFS_PHY_RESET_ENABLE),
>+ REG_UFS_CFG1);
>
> /*
> * Make sure assertion of ufs phy reset is written to
>@@ -154,8 +149,8 @@ static inline void ufs_qcom_assert_reset(struct ufs_hba *hba)
>
> static inline void ufs_qcom_deassert_reset(struct ufs_hba *hba)
> {
>- ufshcd_rmwl(hba, MASK_UFS_PHY_SOFT_RESET,
>- 0 << OFFSET_UFS_PHY_SOFT_RESET, REG_UFS_CFG1);
>+ ufshcd_rmwl(hba, UFS_PHY_SOFT_RESET, FIELD_PREP(UFS_PHY_SOFT_RESET, UFS_PHY_RESET_DISABLE),
>+ REG_UFS_CFG1);
>
> /*
> * Make sure de-assertion of ufs phy reset is written to
>--
>2.25.1
>
More information about the linux-phy
mailing list