[PATCH v3 6/9] dt-bindings: imx6q-pcie: Add PHY phandles and name properties

Richard Zhu hongxing.zhu at nxp.com
Thu Oct 21 19:04:41 PDT 2021


> -----Original Message-----
> From: Rob Herring <robh at kernel.org>
> Sent: Tuesday, October 19, 2021 3:18 AM
> To: Richard Zhu <hongxing.zhu at nxp.com>
> Cc: l.stach at pengutronix.de; tharvey at gateworks.com; kishon at ti.com;
> vkoul at kernel.org; galak at kernel.crashing.org; shawnguo at kernel.org;
> linux-phy at lists.infradead.org; devicetree at vger.kernel.org;
> linux-arm-kernel at lists.infradead.org; linux-kernel at vger.kernel.org;
> kernel at pengutronix.de; dl-linux-imx <linux-imx at nxp.com>
> Subject: Re: [PATCH v3 6/9] dt-bindings: imx6q-pcie: Add PHY phandles and
> name properties
> 
> On Tue, Oct 12, 2021 at 04:41:15PM +0800, Richard Zhu wrote:
> > i.MX8MM PCIe has the PHY. Add a PHY phandle and name properties in the
> > binding document.
> >
> > Signed-off-by: Richard Zhu <hongxing.zhu at nxp.com>
> > ---
> >  Documentation/devicetree/bindings/pci/fsl,imx6q-pcie.yaml | 6 ++++++
> >  1 file changed, 6 insertions(+)
> >
> > diff --git a/Documentation/devicetree/bindings/pci/fsl,imx6q-pcie.yaml
> > b/Documentation/devicetree/bindings/pci/fsl,imx6q-pcie.yaml
> > index 2911e565b260..99d9863a69cd 100644
> > --- a/Documentation/devicetree/bindings/pci/fsl,imx6q-pcie.yaml
> > +++ b/Documentation/devicetree/bindings/pci/fsl,imx6q-pcie.yaml
> > @@ -128,6 +128,12 @@ properties:
> >      enum: [1, 2, 3, 4]
> >      default: 1
> >
> > +  phys:
> > +    description: Phandle of the Generic PHY to the PCIe PHY.
> 
> maxItems: 1
> 
> And drop 'description'
[Richard Zhu] Hi Rob: 
Do you mean to remove all the description, and just like this?
  phys:
    maxItems: 1
Ok, got that, would be changed as this one in v4 series later.
Thanks.

Best Regards
Richard Zhu

> 
> > +
> > +  phy-names:
> > +    const: pcie-phy
> > +
> >    reset-gpio:
> >      description: Should specify the GPIO for controlling the PCI bus
> device
> >        reset signal. It's not polarity aware and defaults to
> > active-low reset
> > --
> > 2.25.1
> >
> >



More information about the linux-phy mailing list