[PATCH RFC v2 0/4] MUX: Add support for reading enable state from DT

[Aswath Govindraju]

Hi All,

On 22/11/21 6:26 pm, Aswath Govindraju wrote:
> - The following series of patches add support for reading the state of the
>   mux to be set for enabling given device.
> - As these are RFC patches I have combined them into a single series for
>   better understanding of the reason behind making this change.
> 
> Changes since v1:
> - Added support for reading the enable state from DT instead of hardcoding
>   the state to be set to 1.
> - Made relavent changes in the bindings
> 
> Link to v1,
> - https://patchwork.kernel.org/project/linux-phy/list/?series=578863&state=*
> 
> Aswath Govindraju (4):
>   dt-bindings: mux: Increase the number of arguments in mux-controls
>   dt-bindings: phy: ti,tcan104x-can: Document mux-controls property
>   mux: Add support for reading mux enable state from DT
>   phy: phy-can-transceiver: Add support for setting mux
> 

Thank you for the comments. I have made changes based on the comments
received and posted a v3 of this series.

Regards,
Aswath

>  .../devicetree/bindings/mux/gpio-mux.yaml     |  2 +-
>  .../bindings/mux/mux-controller.yaml          |  2 +-
>  .../bindings/phy/ti,tcan104x-can.yaml         |  8 ++++++
>  drivers/mux/core.c                            | 20 ++++++++++++--
>  drivers/phy/phy-can-transceiver.c             | 26 +++++++++++++++++++
>  include/linux/mux/consumer.h                  |  1 +
>  include/linux/mux/driver.h                    |  1 +
>  7 files changed, 56 insertions(+), 4 deletions(-)
>