[PATCH RFC 0/2] CAN TRANSCEIVER: Add support for setting mux

[Aswath Govindraju]

On some boards, for routing CAN signals from controller to transceiver,
muxes might need to be set. Therefore, add support for setting the mux by
reading the mux-controls property from the device tree node.

Aswath Govindraju (2):
  dt-bindings: phy: ti,tcan104x-can: Document mux-controls property
  phy: phy-can-transceiver: Add support for setting mux

 .../bindings/phy/ti,tcan104x-can.yaml         |  6 ++++++
 drivers/phy/phy-can-transceiver.c             | 21 +++++++++++++++++++
 2 files changed, 27 insertions(+)

-- 
2.17.1