[PATCH v2 08/18] media: cadence: csi2rx: Set the STOP bit when stopping a stream

Pratyush Yadav p.yadav at ti.com
Wed May 26 08:22:58 PDT 2021


The stream stop procedure says that the STOP bit should be set when the
stream is to be stopped, and then the ready bit in stream status
register polled to make sure the STOP operation is finished.

Signed-off-by: Pratyush Yadav <p.yadav at ti.com>
---

(no changes since v1)

 drivers/media/platform/cadence/cdns-csi2rx.c | 18 +++++++++++++++++-
 1 file changed, 17 insertions(+), 1 deletion(-)

diff --git a/drivers/media/platform/cadence/cdns-csi2rx.c b/drivers/media/platform/cadence/cdns-csi2rx.c
index 80a50284e525..ecc43a618c34 100644
--- a/drivers/media/platform/cadence/cdns-csi2rx.c
+++ b/drivers/media/platform/cadence/cdns-csi2rx.c
@@ -8,6 +8,7 @@
 #include <linux/clk.h>
 #include <linux/delay.h>
 #include <linux/io.h>
+#include <linux/iopoll.h>
 #include <linux/module.h>
 #include <linux/of.h>
 #include <linux/of_graph.h>
@@ -40,8 +41,12 @@
 
 #define CSI2RX_STREAM_CTRL_REG(n)		(CSI2RX_STREAM_BASE(n) + 0x000)
 #define CSI2RX_STREAM_CTRL_SOFT_RST			BIT(4)
+#define CSI2RX_STREAM_CTRL_STOP				BIT(1)
 #define CSI2RX_STREAM_CTRL_START			BIT(0)
 
+#define CSI2RX_STREAM_STATUS_REG(n)		(CSI2RX_STREAM_BASE(n) + 0x004)
+#define CSI2RX_STREAM_STATUS_RDY			BIT(31)
+
 #define CSI2RX_STREAM_DATA_CFG_REG(n)		(CSI2RX_STREAM_BASE(n) + 0x008)
 #define CSI2RX_STREAM_DATA_CFG_EN_VC_SELECT		BIT(31)
 #define CSI2RX_STREAM_DATA_CFG_VC_SELECT(n)		BIT((n) + 16)
@@ -336,12 +341,23 @@ static int csi2rx_start(struct csi2rx_priv *csi2rx)
 static void csi2rx_stop(struct csi2rx_priv *csi2rx)
 {
 	unsigned int i;
+	u32 val;
+	int ret;
 
 	clk_prepare_enable(csi2rx->p_clk);
 	clk_disable_unprepare(csi2rx->sys_clk);
 
 	for (i = 0; i < csi2rx->max_streams; i++) {
-		writel(0, csi2rx->base + CSI2RX_STREAM_CTRL_REG(i));
+		writel(CSI2RX_STREAM_CTRL_STOP,
+		       csi2rx->base + CSI2RX_STREAM_CTRL_REG(i));
+
+		ret = readl_relaxed_poll_timeout(csi2rx->base +
+						 CSI2RX_STREAM_STATUS_REG(i),
+						 val,
+						 (val & CSI2RX_STREAM_STATUS_RDY),
+						 10, 10000);
+		if (ret)
+			dev_warn(csi2rx->dev, "Failed to stop stream%d\n", i);
 
 		clk_disable_unprepare(csi2rx->pixel_clk[i]);
 	}
-- 
2.30.0




More information about the linux-phy mailing list