[PATCH 10/14] phy: cadence-torrent: Add function to get PLL to be configured for DP

Kishon Vijay Abraham I kishon at ti.com
Thu May 13 00:12:55 PDT 2021


Hi Swapnil,

On 09/04/21 11:04 am, Swapnil Jakhade wrote:
> Torrent PHY PLL0 or PLL1 is used for DP depending on the single link or
> multilink protocol configuration for which PHY is configured. In multilink
> configurations with other protocols, either PLL0 or PLL1 will be used
> for DP. For single link DP, both PLLs need to be configured at POR.
> 
> Signed-off-by: Swapnil Jakhade <sjakhade at cadence.com>
> ---
>  drivers/phy/cadence/phy-cadence-torrent.c | 32 +++++++++++++++++++++++
>  1 file changed, 32 insertions(+)
> 
> diff --git a/drivers/phy/cadence/phy-cadence-torrent.c b/drivers/phy/cadence/phy-cadence-torrent.c
> index e4dd8d1711a6..44e28ea8ffa7 100644
> --- a/drivers/phy/cadence/phy-cadence-torrent.c
> +++ b/drivers/phy/cadence/phy-cadence-torrent.c
> @@ -288,6 +288,11 @@ enum cdns_torrent_ssc_mode {
>  	INTERNAL_SSC
>  };
>  
> +enum cdns_torrent_dp_pll {
> +	DP_PLL0 = 0x1,
> +	DP_PLL1 = 0x2

Using BIT() macro might be better since you are using this as bitfield.
> +};
> +
>  struct cdns_torrent_inst {
>  	struct phy *phy;
>  	u32 mlane;
> @@ -301,6 +306,7 @@ struct cdns_torrent_phy {
>  	void __iomem *base;	/* DPTX registers base */
>  	void __iomem *sd_base; /* SD0801 registers base */
>  	u32 max_bit_rate; /* Maximum link bit rate to use (in Mbps) */
> +	u32 dp_pll;

enum cdns_torrent_dp_pll?

Thanks
Kishon

>  	struct reset_control *phy_rst;
>  	struct reset_control *apb_rst;
>  	struct device *dev;
> @@ -900,6 +906,30 @@ void cdns_torrent_dp_pma_cmn_vco_cfg_100mhz(struct cdns_torrent_phy *cdns_phy,
>  	}
>  }
>  
> +/* Set PLL used for DP configuration */
> +static int cdns_torrent_dp_get_pll(struct cdns_torrent_phy *cdns_phy,
> +				   enum cdns_torrent_phy_type phy_t2)
> +{
> +	switch (phy_t2) {
> +	case TYPE_PCIE:
> +	case TYPE_USB:
> +		cdns_phy->dp_pll = DP_PLL1;
> +		break;
> +	case TYPE_SGMII:
> +	case TYPE_QSGMII:
> +		cdns_phy->dp_pll = DP_PLL0;
> +		break;
> +	case TYPE_NONE:
> +		cdns_phy->dp_pll = DP_PLL0 | DP_PLL1;
> +		break;
> +	default:
> +		dev_err(cdns_phy->dev, "Unsupported PHY configuration\n");
> +		return -EINVAL;
> +	}
> +
> +	return 0;
> +}
> +
>  /*
>   * Enable or disable PLL for selected lanes.
>   */
> @@ -1554,6 +1584,8 @@ static int cdns_torrent_dp_init(struct phy *phy)
>  		return -EINVAL;
>  	}
>  
> +	cdns_torrent_dp_get_pll(cdns_phy, TYPE_NONE);
> +
>  	cdns_torrent_dp_common_init(cdns_phy, inst);
>  
>  	return cdns_torrent_dp_start(cdns_phy, inst, phy);
> 



More information about the linux-phy mailing list